Re: Ericsson F5521gw hayes command set and descriptions ?
Kurt Jaeger <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Hi!
> > umodem0:<F5521gw Mobile Broadband Modem> on usbus1
> > umodem0: data interface 2, has CM over data, has break
> > umodem1:<F5521gw Mobile Broadband Data Modem> on usbus1
> > umodem1: data interface 4, has CM over data, has break
> > umodem2:<F5521gw Mobile Broadband GPS Port> on usbus1
> > umodem2: data interface 10, has CM over data, has break
> >
> > I tried this on all of them:
> >
> > AT+CPIN=nnnn
> > ERROR
>
> The link [1] mentions something about using USB Ethernet instead of USB
> Serial with this device. Can you try unloading umodem and loading if_cdce?
This might be the case:
cdce0: <F5521gw Mobile Broadband Network Adapter> on usbus1
ue0: <USB Ethernet> on cdce0
ue0: Ethernet address: 02:80:37:ec:02:00
And indeed, ue0 is listed with ifconfig:
$ ifconfig ue0
ue0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
ether 02:80:37:ec:02:00
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
> That's my last idea in this subject I think. Insecure solution would be
> removing PIN from the SIM but it'll tell you if the modem even can
> connect to the network.
I'll investigate this, thanks!
--
[email protected] +49 171 3101372 9 years to go !
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"