ThinkPad 380ED doesn't work with FreeBSD 8.2-release
Torfinn Ingolfsen <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Hi, I fired up an old workhorse today: the ThinkPad 380ED[1]. Unfortunately, it doesn't work properly with FreeBSD 8.2-release, it seems like a PCI bridge isn't detected, or detected incorrectly. Perhaps this is the reason why the PCI-PCMCIA bridge isn't getting a driver too? Output from dmesg: pci0: <bridge> at device 1.0 (no driver attached) vgapci0: <VGA-compatible display> mem 0x8000000-0x83fffff irq 11 at device 3.0 on pci0 pci0: <bridge, PCI-PCMCIA> at device 19.0 (no driver attached) I tested with FreeBSD 7.4-release too, the same problem. dmesg output: pci0: <bridge> at device 1.0 (no driver attached) vgapci0: <VGA-compatible display> mem 0x8000000-0x83fffff irq 11 at device 3.0 on pci0 pci0: <bridge, PCI-PCMCIA> at device 19.0 (no driver attached) Is this problem / failure something that is easy to fix? The machine works under FreeBSD 4.11-release, the relevant parts from dmesg looks like this: pcib0: <Host to PCI bridge> on motherboard pci0: <PCI bus> on pcib0 chip1: <PCI to Other bridge (vendor=8086 device=1234)> at device 1.0 on pci0 pci0: <NeoMagic MagicGraph 128ZV SVGA controller> at 3.0 irq 11 pcic0: <Cirrus Logic PD6729/6730 PCI-PCMCIA Bridge> port 0x3e0-0x3e3 at device 19.0 on pci0 pcic0: Polling mode pccard0: <PC Card 16-bit bus (classic)> on pcic0 pccard1: <PC Card 16-bit bus (classic)> on pcic0 More info, full dmesg output (normal and verbose), etc at the FreeBSD page[2] for this machine. References: 1) http://sites.google.com/site/tingox/tp380ed 2) http://sites.google.com/site/tingox/tp380ed_freebsd -- Torfinn _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"