Re: Thinkpad T410: resume broken
Jan Henrik Sylvester <[email protected]>
| Newsgroups | gmane.os.freebsd.current,gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On 05/21/2014 21:22, Hans Petter Selasky wrote: > On 05/21/14 21:16, Jan Henrik Sylvester wrote: >> Unfortunately, my USB mouse does not work anymore: After the first >> resume, it took a few seconds until it worked again (the build in >> touchpad was back immediately). After the second resume, it would not >> work anymore at all, even after reconnecting it to a different EHCI >> port. It does work at a XHCI, though, until the next resume. Anyhow, >> this is obviously not related to the original problem. > > Hi, > > USB controller are being reset at resume, so I think this indicates a > more fundamental PCI/BUS problem. Looking through dmesg, it seems that other USB devices (build-in) are reappearing (Qualcomm Gobi 2000, Broadcom Bluetooth Device) after resume, just not the mouse. Are these lines likely related? pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.PEG_: AE_BAD_PARAMETER pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.EXP1: AE_BAD_PARAMETER pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.EXP2: AE_BAD_PARAMETER pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.EXP4: AE_BAD_PARAMETER pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.EXP5: AE_BAD_PARAMETER Thanks, Jan Henrik _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "[email protected]"