Re: TI1250 don't route IRQ

On Wed, Aug 14, 2002 at 10:56:30PM -0600, M. Warner Losh wrote:
> In message: <[email protected]>
>             Vitaly Markitantov <[email protected]> writes:
> : pcibios: PCI BIOS entry at 0xfd810+0x203
> 
> : pcic0: chip is in D3 power mode -- setting to D0
> 
> This is interesting....  And may be the problem.  D3 is the "off"
> state.
> 
> : pci_cfgintr_linked: linked (60) to hard-routed irq 11
> : pci_cfgintr: 0:3 INTA routed to irq 11
> 
> This looks OK and typical.
> 
> : pcic0: <TI PCI-1250 PCI-CardBus Bridge> irq 11 at device 3.0 on pci0
> : pcic0: PCI Memory allocated: 0x88000000
> 
> OK, the memory address isn't assigned by the bios, maybe another
> clue.
> 
> : pcic0: TI12XX PCI Config Reg: [speaker enable][pwr save][FUNC pci int + CSC serial isa irq]
> 
> This looks reasonable.
>
> .......
>
> That's a really long way of saying "Looks good to me.."
> 
> I'm still concerned about the D3 state, but don't know more about it.
> 

Thanks for explanation. It looks good, but don't works with my pc-cards.
So, i must drop my laptop to trash, or keep trying to work in M$ windows :(

-- 
 Vitaly Markitantov         mailto: [email protected]
     icq: 117438950          phone: (062)332-23-90

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message