Winmodem question

Hello,

I am trying to get FreeBSD 4.5 working on a Toshiba Portege 2000. So far 
so good (sound, X, built-in wavelan etc works fine), but I haven't got the 
winmodem to work. Since I haven't had a laptop with a winmodem before, I 
am not really sure what to do...

Under Windows the modem is shown as "Toshiba software modem AMR", 
manufacturer "LT" and uses the driver "LTSM.SYS", so I guess it is a 
Lucent modem.

I have installed the ltmdm port without problems, and the module loads 
without a comment, but the modem doesn't respond:

root@porter 42# tip winmodem
tip: /dev/cual0: Device not configured
link down

I have seen some mails describing "winmodem" being displayed by dmesg, but 
I see no such thing, the one I guess is the winmodem is the following:

pci0: <unknown card> (vendor=0x1179, dev=0x0805) at 18.0 irq 11

What have I forgotten to do to make the winmodem to work??

--Borje

PS Is there an equivalent to the Linux toshutils (Toshiba utilities) 
available for FreeBSD??


To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message