Problems suspending with snd_maestro3
"Daniel O'Connor" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
I have a Dell Inspiron 8000 which has an ESS Maestro 3 sound chipset. I find that after an upgrade to 4.6-STABLE (as of yesterday) the machine crashes on suspend. I get a panic message printed briefly just before the machine resets :-/ I normally load the Maestro driver in the boot loader, however if I load it from /etc/rc.local it works fine on suspend (no panic) Curiously the master volume is set to 0 if I load from the loader, but is normal when loaded as a module(!) I've attached dmesg output. Does anyone else see this problem and/or have a fix? :) Thanks. -- Daniel O'Connor software and network engineer for Genesis Software - http://www.gsoft.com.au "The nice thing about standards is that there are so many of them to choose from." -- Andrew Tanenbaum GPG Fingerprint - 9A8C 569F 685A D928 5140 AE4B 319B 41F4 5D17 FDD5
dmesg.txt
(text/plain, 4.9 KB)
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.6-STABLE #1: Tue Aug 27 12:00:04 CST 2002
[email protected]:/usr/obj/usr/src/sys/CHOWDER
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (697.68-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x686 Stepping = 6
Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory = 134127616 (130984K bytes)
avail memory = 127254528 (124272K bytes)
Preloaded elf kernel "kernel" at 0xc033d000.
Preloaded elf module "if_wi.ko" at 0xc033d09c.
Preloaded elf module "usb.ko" at 0xc033d13c.
Preloaded elf module "ugen.ko" at 0xc033d1d8.
Preloaded elf module "ums.ko" at 0xc033d274.
Preloaded elf module "agp.ko" at 0xc033d310.
Pentium Pro MTRR support enabled
Using $PIR table, 10 entries at 0xc00fbc20
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
agp0: <Intel Generic host to PCI bridge> mem 0xe4000000-0xe7ffffff at device 0.0 on pci0
pcib1: <Intel 82801BA/BAM (ICH2) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <ATI model 4d46 graphics accelerator> at 0.0 irq 11
pcib2: <PCI to PCI bridge (vendor=8086 device=2448)> at device 30.0 on pci0
pci2: <PCI bus> on pcib2
pci2: <unknown card> (vendor=0x125d, dev=0x1998) at 3.0 irq 5
pcib3: <PCI to PCI bridge (vendor=1668 device=0100)> at device 6.0 on pci2
pci8: <PCI bus> on pcib3
pci8: <unknown card> (vendor=0x8086, dev=0x1229) at 4.0 irq 11
pci8: <unknown card> (vendor=0x11c1, dev=0x0448) at 8.0 irq 11
pcic0: <TI PCI-4451 PCI-CardBus Bridge> irq 11 at device 15.0 on pci2
pcic0: PCI Memory allocated: 0x88000000
pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][CSC serial isa irq]
pccard0: <PC Card bus (classic)> on pcic0
pcic1: <TI PCI-4451 PCI-CardBus Bridge> irq 11 at device 15.1 on pci2
pcic1: PCI Memory allocated: 0x88001000
pcic1: TI12XX PCI Config Reg: [ring enable][speaker enable][CSC serial isa irq]
pccard1: <PC Card bus (classic)> on pcic1
pci2: <unknown card> (vendor=0x104c, dev=0x8027) at 15.2 irq 11
isab0: <PCI to ISA bridge (vendor=8086 device=244c)> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH2 ATA100 controller> port 0xbfa0-0xbfaf at device 31.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> port 0xbce0-0xbcff irq 11 at device 31.2 on pci0
usb0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
orm0: <Option ROM> at iomem 0xc0000-0xcffff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to accept, logging disabled
IPsec: Initialized Security Association Processing.
ad0: DMA limited to UDMA33, non-ATA66 cable or device
ad0: 9590MB <IBM-DJSA-210> [19485/16/63] at ata0-master UDMA33
acd0: CDROM <TEAC CD-ROM CD-224E> at ata0-slave PIO4
Mounting root from ufs:/dev/ad0s3a
fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0xecc0-0xecff mem 0xf8e00000-0xf8efffff,0xf8fff000-0xf8ffffff irq 11 at device 4.0 on pci8
fxp0: Ethernet address 00:20:e0:65:13:1d
inphy0: <i82555 10/100 media interface> on miibus0
inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pcm0: <ESS Technology Maestro3> port 0xdc00-0xdcff mem 0xf6ffe000-0xf6ffffff irq 5 at device 3.0 on pci2
ltmdm0: <Lucent Winmodem> port 0xe800-0xe8ff,0xecb8-0xecbf mem 0xf8ffec00-0xf8ffecff irq 11 at device 8.0 on pci8
ltmdm0: type Virtual 16550A
resumed from suspended mode (slept 00:01:24)
ata0: resetting devices .. ad0: DMA limited to UDMA33, non-ATA66 cable or device
done
ata1: resetting devices .. done
ums0: Logitech USB-PS/2 Trackball, rev 1.00/2.10, addr 2, iclass 3/1
ums0: 3 buttons and Z dir.