Re: Intel Mobile fxp Cardbus cards supported?

In message: <[email protected]>
            Vincent Poy <[email protected]> writes:
: On Fri, 20 Sep 2002, M. Warner Losh wrote:
: 
: > In message: <[email protected]>
: >             Vincent Poy <[email protected]> writes:
: > : 	Which model of the cardbus card are you using?  I'm going to try
: > : the MBLA3300C3 next which is the one without the modem.
: >
: > MBLA3300 is the one that I've used.
: >
: > fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0x1000-0x103f mem 0xf4020000-0xf403ffff,0xf4040000-0xf4040fff irq 10 at device 0.0 on cardbus0
: > fxp0: Disabling dynamic standby mode in EEPROM
: > fxp0: New EEPROM ID: 0x4880
: > fxp0: EEPROM checksum @ 0xff: 0x7a17 -> 0x7a19
: > fxp0: Ethernet address 00:d0:b7:02:0e:f6
: > inphy0: <i82555 10/100 media interface> on miibus0
: > inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
: >
: > is what dmesg says when I insert the card.  I've not used it in a
: > little while, but the new EEPROM ID is something I should look into.

I only get that message once.

: 	After trying the MBLA3300, MBLA3300C3, MBLA3356C3 on both the IBM
: ThinkPad 770Z and the Dell Inspiron 8200, all three cards had the
: following results:

Then there's something wrong with these machines.  The MBLA3300 works
pefectly on my inspiron 8000.  Something else must be keeping you from
using these cards on the machines that you are trying it on.  It is
clear from the behavior that these machines can't memory map to
0xf4020000 because all reads from the card appear to return
0xffffffff.

Warner

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message