Re: Sierra Wireless Aircard 750 GSM/GPRS

Kirill Bezzubets <[email protected]>
Newsgroups gmane.os.freebsd.devel.mobile
Message-ID <[email protected]>
On Mon, Oct 14, 2002 at 04:49:41PM +0100, Julian Chesterfield wrote:

> 
> sio4 at port 0x240-0x27f irq 9 flags 0x40000 slot 0 on pccard0
> sio4: type 8250

8250?.. Hmm.. Even my old USR Megahertz shows up as 16550A sio..

> sio4: unable to activate interrupt in fast mode - using normal mode
> 
That's ok - it's common message.

> which seems to indicate that the hardware is working. The specs from Sierra 
> tell me that the communication settings for the host machine should be 
> 115kbps, 8-bit, no parity and one stop bit. This is where I have trouble 
> understanding what happens. At this stage, I just want to be able to 
> communicate with the modem and issue AT commands to check whether it's working 
> etc.. but I can't get any feedback at all. I've read through the handbook on 
> setting up serial lines/modems but don't fully understand what applies to my 
> situation. My understanding is that the ttyd* device must be enabled to point 
> to the sio interface in order for the system to communicate with the wireless 
> interface.

Wrong. Read handbook carefully - ttyd* are for _incoming_ connections.
For outgoing there are cuaa*.


> How should I setup the tty interface? I've tried modifying the /etc/ttys line 
> as indicated in the handbook as:
> 
> ttyd0 "/usr/libexec/getty std.115200" dialup on secure

sio4=ttyd4, but it doesn't matter for your situation. Just remove that line.

> 
> this starts a getty process but doesn't seem to help when I run cu or tip, I 
> get a "Line in use" error command.
> 
> When I run cu or tip without the getty process active, the application runs 
> but I get no response to my typing.

Use /dev/cuaa4 as device to connect to.

> 
> Can someone point me in the right direction on what is supposed to happen, and 
> how the configuration should be done? Any help much appreciated,
> 

And, again, if your card is looking as 8250 to system, there might be
troubles using port speed greater than 9600.

-- 
BR,
Kirill Bezzubets                                CASE-RIPE CASE-RIPN
Senior Administrator, Technical Department      mailto:[email protected]
Solaris ISP & Telecommunications Co. Ltd        http://www.solaris.ru

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.