Re: problems with upgrade

Kevin,

I think the dmesg looks OK, IIRC.

>>   sio1: configured irq 3 not in bitmap of probed irqs 0

On my TP600 with 4.3-stable this is what I get without mwavedd
kldload'ed, but imodem definitely enabled on irq's 3 and 10

>>   mwave0: <mwave> on isa0
>>   Mwave Modem, UART settings IRQ 0x3   IO 0x2f8
>>   sio1 at port 0x2f8-0x2ff irq 3 on isa0
>>   sio1: type 16550A

I think this is the result of kldload mwavedd [sadly I can't get mwave
to make on my 4.3-stable to verify my memory from 4.1].  Without the
mwavedd device driver there is no sio1.

HTH,

Greg

-----Original Message-----

>> Date: Fri, 18 Oct 2002 19:19:25 -0700
>> From: Dave Walton <[email protected]>
>> Sender: [email protected]
>> 
>> I recently did a cvsup upgrade from 4.4 to 4.6.2 on my thinkpad.  At
the
>> same time, I upgraded the mwavem port to the latest version.  The
modem
>> was working fine before the upgrade, but now it's broken.
>> 
>> 'dmesg' reports:
>> 
>>   sio1: configured irq 3 not in bitmap of probed irqs 0
>>   ...
>>   mwave0: <mwave> on isa0
>>   Mwave Modem, UART settings IRQ 0x3   IO 0x2f8
>>   sio1 at port 0x2f8-0x2ff irq 3 on isa0
>>   sio1: type 16550A
>>   ...
>>   pid 197 (mwavem), uid 0: exited on signal 11 (core dumped)
>>   Oct 16 20:56:26 thinkpad770z /kernel: pid 197 (mwavem), uid 0:
exited
>on
>> signal 11 (core dumped)
>> 
>> 
>> What might be the problem here?
>
>Dave,
>
>The line from the dmesg output is the key one. It says that your BIOS
>does not think IRQ3 is used. I'm not sure what this might have to do
>with the cvsup, though. The coincidence bothers me.
>
>To get started, try using ps2 to check the BIOS. Either boot windows
>or the standalone floppy version and print the status of the internal
>modem. It should be enabled and be using IRQ3 and 10. You can check on
>IRQs that are mapped with 'ps2 ? irq'.
>
>I am no longer regularly using a system with an mWave, but I will fire
>it up Monday and install 4.6.2 if I have not heard any word on whether
>you had any luck.
>
>R. Kevin Oberman, Network Engineer
>Energy Sciences Network (ESnet)
>Ernest O. Lawrence Berkeley National Laboratory (Berkeley Lab)
>E-mail: [email protected]			Phone: +1 510 486-8634
>
>
>To Unsubscribe: send mail to [email protected]
>with "unsubscribe freebsd-mobile" in the body of the message




To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message