USB on IBM ThinkPad X30

Has anyone had success in connecting USB devices to IBM ThinkPad X30?
When I plug in an USB device (Olympus C3040, for example), nothing
happens at all. Here is a dmesg output:

Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994

 The Regents of the University of California. All rights reserved.
FreeBSD 4.7-RELEASE #4: Tue Oct 22 11:10:43 CEST 2002
    marko@tpx30:/opt/src/sys/compile/TPX30
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (1196.02-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x6b1  Stepping = 1

Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>

real memory  = 259391488 (253312K bytes)
avail memory = 249081856 (243244K bytes)
Preloaded elf kernel "kernel" at 0xc0345000.
Preloaded elf module "vesa.ko" at 0xc034509c.
Preloaded elf module "snd_ich.ko" at 0xc0345138.
Preloaded elf module "snd_pcm.ko" at 0xc03451d8.
VESA: v3.0, 8000k memory, flags:0x1, mode table:0xc03242c0 (1000040)
VESA: Almador Graphics Chip Accelerated VGA BIOS
Pentium Pro MTRR support enabled
md0: Malloc disk
Using $PIR table, 13 entries at 0xc00fdec0
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
agp0: <Intel 82830 (i830M GMCH) SVGA controller> mem
0xd0000000-0xd007ffff,0xe0000000-0xe7ffffff irq 9 at device 2.0 on pci0
agp0: detected 8060k stolen memory
agp0: aperture size is 128M
pci0: <unknown card> (vendor=0x8086, dev=0x3577) at 2.1
uhci0: <Intel 82801CA/CAM (ICH3) USB controller USB-A> port
0x1800-0x181f irq 9 at device 29.0 on pci0
usb0: <Intel 82801CA/CAM (ICH3) USB controller USB-A> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1: <Intel 82801CA/CAM (ICH3) USB controller USB-B> port
0x1820-0x183f irq 11 at device 29.1 on pci0
usb1: <Intel 82801CA/CAM (ICH3) USB controller USB-B> on uhci1
usb1: USB revision 1.0
uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
uhci2: <Intel 82801CA/CAM (ICH3) USB controller USB-C> port
0x1840-0x185f irq 10 at device 29.2 on pci0
usb2: <Intel 82801CA/CAM (ICH3) USB controller USB-C> on uhci2
usb2: USB revision 1.0
uhub2: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub2: 2 ports with 2 removable, self powered
pcib1: <PCI to PCI bridge (vendor=8086 device=2448)> at device 30.0 on
pci0
pci1: <PCI bus> on pcib1
pcic0: <Ricoh RL5C476 PCI-CardBus Bridge> mem 0x50000000-0x50000fff irq
9 at device 0.0 on pci1
pccard0: <PC Card 16-bit bus (classic)> on pcic0
pcic1: <Ricoh RL5C476 PCI-CardBus Bridge> mem 0x50100000-0x50100fff irq
5 at device 0.1 on pci1
pccard1: <PC Card 16-bit bus (classic)> on pcic1
pci1: <unknown card> (vendor=0x1180, dev=0x0552) at 0.2 irq 10
fxp0: <Intel Pro/100 Ethernet> port 0x7000-0x703f mem
0xd0200000-0xd0200fff irq 11 at device 8.0 on pci1
fxp0: Ethernet address 00:09:6b:e0:d5:fc
inphy0: <i82562ET 10/100 media interface> on miibus0
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
isab0: <PCI to ISA bridge (vendor=8086 device=248c)> at device 31.0 on
pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH3 ATA100 controller> port
0x1860-0x186f,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 at device
31.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0: <unknown card> (vendor=0x8086, dev=0x2483) at 31.3 irq 5
pcm0: <Intel 82801CA (ICH3)> port 0x18c0-0x18ff,0x1c00-0x1cff irq 5 at
device 31.5 on pci0
pci0: <unknown card> (vendor=0x8086, dev=0x2486) at 31.6 irq 5
orm0: <Option ROMs> at iomem
0xc0000-0xcdfff,0xce000-0xcefff,0xcf000-0xcffff,0xdc000-0xdffff,0xe0000-0xeffff
on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on
isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode
ppi0: <Parallel I/O> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ad0: 38154MB <HITACHI_DK23EA-40B> [77520/16/63] at ata0-master UDMA100
Mounting root from ufs:/dev/ad0s1a

Of course USB works flawlessly under M$ XP...

Marko


To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-hardware" in the body of the message