Re: USB attach fails on ASUS P6300 with 4.5-RELEASE:

Hi,

thanks for looking into this!

>>>>> "Nick" == Nick Hibma <[email protected]> writes:

Nick> This seems to fail in the BIOS. Could you check whether you have irq 3
Nick> allocated to legacy ISA interrupts?

In the BIOS you mean?  Indeed, IRQ 3 is manually configured to be for
the IR serial port.  But even when that is disabled, things are broken
the same way.

Nick> 3 is a bit of an odd value. Do you have sio ports in that machine? COuld
Nick> you post the dmesg (or /var/run/dmesg.boot) of the machine?

Indeed irq 3 is allocated for sio1, and there's something funny going
on there indeed.  (I never quite understood this "not in bitmap of
probed irqs" message.)

-- 
Cheers =8-} Mike
Friede, Völkerverständigung und überhaupt blabla

Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD 4.5-RELEASE #0: Mon Jan 28 14:31:56 GMT 2002
    [email protected]:/usr/src/sys/compile/GENERIC
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium/P55C (quarter-micron) (267.27-MHz 586-class CPU)
  Origin = "GenuineIntel"  Id = 0x581  Stepping = 1
  Features=0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX>
real memory  = 100663296 (98304K bytes)
config> di sn0
config> di lnc0
config> di ie0
config> di fe0
config> di ed0
config> di cs0
config> di bt0
config> di aic0
config> di aha0
config> di adv0
config> q
avail memory = 93200384 (91016K bytes)
Preloaded elf kernel "kernel" at 0xc0496000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc049609c.
Intel Pentium detected, installing workaround for F00F bug
md0: Malloc disk
Using $PIR table, 5 entries at 0xc00fdf70
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pci0: <NeoMagic MagicGraph 128XD SVGA controller> at 2.0 irq 11
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xfcd0-0xfcdf at device 7.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0xfce0-0xfcff at device 7.2 on pci0
pci_cfgintr_virgin: using routable interrupt 3
pci_cfgintr: ROUTE_INTERRUPT failed.
uhci0: Could not allocate irq
device_probe_and_attach: uhci0 attach returned 6
chip1: <Intel 82371AB Power management controller> port 0x2180-0x218f at device 7.3 on pci0
pci_cfgintr_linked: linked (60) to hard-routed irq 11
pci_cfgintr: 0:10 INTA routed to irq 11
pcic0: <TI PCI-1131 PCI-CardBus Bridge> irq 11 at device 10.0 on pci0
pcic0: PCI Memory allocated: 0x44000000
pcic0: TI113X PCI Config Reg: [speaker enable][CSC serial isa irq]
pccard0: <PC Card bus (classic)> on pcic0
pci_cfgintr_linked: linked (61) to hard-routed irq 11
pci_cfgintr: 0:10 INTB routed to irq 11
pcic1: <TI PCI-1131 PCI-CardBus Bridge> irq 11 at device 10.1 on pci0
pcic1: PCI Memory allocated: 0x44001000
pcic1: TI113X PCI Config Reg: [speaker enable][CSC serial isa irq]
pccard1: <PC Card bus (classic)> on pcic1
orm0: <Option ROM> at iomem 0xc0000-0xc9fff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
ad0: 3091MB <HITACHI_DK226A-32U> [6282/16/63] at ata0-master UDMA33
Mounting root from ufs:/dev/ad0s1a
pccard: card inserted, slot 1