RE: Linksys WMP11
"Sanjay Waghray" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
> >
> > You might try the following patch:
> >
> > Index: if_wi_pci.c
> > ===================================================================
> > RCS file: /home/ncvs/src/sys/dev/wi/if_wi_pci.c,v
> > retrieving revision 1.8.2.3
> > diff -u -r1.8.2.3 if_wi_pci.c
> > --- if_wi_pci.c 16 Jun 2002 18:07:18 -0000 1.8.2.3
> > +++ if_wi_pci.c 23 Dec 2002 13:22:12 -0000
> > @@ -140,7 +140,7 @@
> > command |= wanted;
> > pci_write_config(dev, PCIR_COMMAND, command, 4);
> > command = pci_read_config(dev, PCIR_COMMAND, 4);
> > - if ((command & wanted) != wanted) {
> > + if ((command & wanted) == 0) {
> > device_printf(dev, "wi_pci_attach() failed to
> > enable pci!\n");
> > return (ENXIO);
> > }
> >
>
> I did and this is what I get:
>
>
> Dec 23 09:30:24 dell /kernel: wi0: <WMP-11> mem
> 0xeb000000-0xeb001fff irq 11
> at device 11.0 on pci0
> Dec 23 09:30:24 dell /kernel: wi0: couldn't reset prism2.5 core.
> Dec 23 09:30:24 dell /kernel: device_probe_and_attach: wi0 attach
> returned 6
>
> Any ideas?
I'm now convinced that Linksys has changed the chipset/firmware
on the WMP11. I installed the card on a Win2000 box and installed
the Intersil utilities and the Linksys 1.4.9 firmware.
I tried to flash the older 1.4.9 firmware without success.
The Intersil utilities do not recognize the card as a Prism.
I'll order the Netgear MA311 which is around $55 after the mail-in
rebate.
Sanjay
To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message