Re: 4.7 -> 5.0 Pccard problems (more info)

On Thu, Dec 26, 2002 at 06:21:10AM -0800, Pat Lathem wrote:

> >>cbb0: <TI1410 PCI-CardBus Bridge> irq 11 at device 6.0 on pci2
> >>cardbus0: <CardBus bus> on cbb0
> >>pccard0: <16-bit PCCard bus> on cbb0
> >>   
> The card is a supported IBM 56k modem (I also have been expirementing 
> with a Linksys wireless card). The kernel does not say anything when I 
> insert or remove it (with GENERIC), which is why I assumed it was not 
> being detected properly. Since I posted the, I have reverted to the 
> kernel OLDCARD. After the computer boots, I can run 'pccardc power 0 1' 
> and it starts to initialize the card, but fails to read the correct 
> vendor string from the pccard. I'm currently changing the hints file (at 
> the advice of Greg Smith) to see if it can work. My question is this: Is 
> this is a regression? In 4.7-stable I only had to add to /etc/rc.conf 
> "pccard_enable="YES"'  and reboot (or start pccardd) to get my cards 
> working. Was I just lucky that it just worked the first time, or is 
> there a problem?

One more thing from your dmesg output (sorry, just noticed..):

cbb0: Unsupported card type detected

I guess it's a kind of bug with TI1410 (???), not sure though.
Because mine is TI1131 PCI-CardBus Bridge and everything works well
with both 16bit(PCCard) and 32bit(CardBus) cards using NEWCARD.
Also it did work in 4-STABLE since 4.3 with PCCards.

My FreeBSD is 5.0-RC1.

Are you using 5-CURRENT or 5.0-RC1? Btw, dmesg from "boot -v" could help
much more to determine what the problem is.

-- 
BR,
Kirill Bezzubets                                CASE-RIPE CASE-RIPN
Senior Administrator, Technical Department      mailto:[email protected]
Solaris ISP & Telecommunications Co. Ltd        http://www.solaris.ru

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message