netgear MA311 not wanting to work with ibook.

"Kevin S. Brackett" <[email protected]>
Newsgroups gmane.os.freebsd.devel.mobile
Message-ID <[email protected]>
The card from dmesg:

wi0: <Intersil Prism2.5> mem 0xef001000-0xef001fff irq 3 at device 9.0 on
pci0
wi0: 802.11 address: 00:09:5b:12:09:8f
wi0: using RF:PRISM2.5 MAC:ISL3874A(Mini-PCI)
wi0: Intersil Firmware: Primary 1.00.07, Station 1.03.06

This is what i'm using to get it going:

/sbin/sysctl net.link.ether.bridge=1
/sbin/sysctl net.link.ether.bridge_cfg="wi0 xl0"
/sbin/sysctl net.inet.ip.forwarding=1
/sbin/ifconfig wi0 ssid ABYSS mediaopt hostap debug up

ifconfig:

xl0: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu 1500
        options=3<RXCSUM,TXCSUM>
        inet 192.168.0.1 netmask 0xffffff00 broadcast 192.168.0.255
        inet6 fe80::201:2ff:fe29:411d%xl0 prefixlen 64 scopeid 0x1
        ether 00:01:02:29:41:1d
        media: Ethernet autoselect (100baseTX <full-duplex>)
        status: active
wi0: flags=8947<UP,BROADCAST,DEBUG,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu
1500
        inet6 fe80::209:5bff:fe12:98f%wi0 prefixlen 64 scopeid 0x2
        ether 00:09:5b:12:09:8f
        media: IEEE 802.11 Wireless Ethernet autoselect <hostap> (DS/2Mbps
<host
ap>)
        status: associated
        ssid ABYSS 1:ABYSS
        stationname "FreeBSD WaveLAN/IEEE node"
        channel 3 authmode OPEN powersavemode OFF powersavesleep 100
        wepmode OFF weptxkey 1

Debugging information:

wihap_shutdown: sc=0xc3e8c000 whi=0xc3e8d06c
wihap_init: sc=0xc3e8c000 whi=0xc3e8d06c
wihap_shutdown: sc=0xc3e8c000 whi=0xc3e8d06c
wihap_init: sc=0xc3e8c000 whi=0xc3e8d06c
wi_start: dropping unassoc dst 00:60:b0:a2:9a:27
wihap_mgmt_input: len=6 MGMT: auth:
wihap_auth_req: station 00:30:65:0a:8a:b7 algo=0x0 seq=0x1
wihap_auth_req: new station
wihap_auth_req: returns status=0x0
wihap_mgmt_input: len=17 MGMT: assoc req:
wihap_assoc_req: from station 00:30:65:0a:8a:b7
wihap_assoc_req: returns status=0x0

Using 5.0-CURRENT from a few weeks ago; here's something odd... i have the
ibook set to use DHCP, and the hostap gateway is running isc-dhcpd, and
the ibook is getting the DHCP information and the ibooks signal bar is
about 90% full.


any ideas?

TIA
- kevin

PS: please CC: replies :)

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.