Re: device.hints and APM/ACPI question
"Kevin Oberman" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
> From: "How Can ThisBe" <[email protected]> > Date: Wed, 15 Jan 2003 13:42:35 +0000 > Sender: [email protected] > > Hi, just trying out -CURRENT on a IBM x21 that was running 4.7-STABLE. > Everything went ok but I did have to do a 'unload kernel', 'load > /boot/kernel' to kick in the -CURRENT kernel. Didn't read UPDATING? Ah, well, I hit this one, too, although I fixed it by installing the new loader as shown in UPDATING. > I've found the new /boot/device.hints to be a little on the confusing > side. I was wondering if there is documented information somewhere > besides in conf/NOTES and man device.hints? Probably not. In general, device.hint is just a replacement for specifying device details in the kernel config file. The majority if the file is just telling the system how to configure ISA devices. I had to add hints for my audio card in my 600E. > The next question is about APM/ACPI - is there any info about which > systems ACPI 'should' work on? I had heaps of problems trying to get ACPI > to work on my laptop, all with almost no success at all. So, I've > disabled ACPI in my /boots/device.hints (hint.acpi.0.disabled="1"), > enabled apm back into my kernel and rc.conf, and commented out the > hint.apm.0.disabled="1" in device.hints. Everything is working fine > now, but should ACPI have worked on an x21? ACPI should work fine on an X21. Make sure that you have the latest BIOS. When you say the it did not work, a bit more detail might be helpful. R. Kevin Oberman, Network Engineer Energy Sciences Network (ESnet) Ernest O. Lawrence Berkeley National Laboratory (Berkeley Lab) E-mail: [email protected] Phone: +1 510 486-8634 To Unsubscribe: send mail to [email protected] with "unsubscribe freebsd-mobile" in the body of the message