problems with SMC 2632W in hostap mode

Hi!

I'm trying to use an SMC 2632W 802.11b wireless card as an access
point.  Clients can associate without any apparent problem, but
things go downhill pretty quickly from there.  If I try to ping
the AP machine from a client, the arp who-has makes it across the
wireless link, but the arp reply never makes it back to the
client.  

Here is my machine:

FreeBSD brooklyn-bridge 4.7-RELEASE-p2 FreeBSD 4.7-RELEASE-p2 #0: Sat Dec 21 01:57:24 PST 2002     jmuelmen@brooklyn-bridge:/usr/obj/usr/src/sys/BROOKLYN-BRIDGE  i386

Here is the card:

Dec 22 00:51:42 brooklyn-bridge /kernel: wi0: <PRISM2STA WaveLAN> port 0x1c00-0x1c3f,0x1880-0x18ff mem 0xf4008000-0xf4008fff irq 10 at device 14.0 on pci0
Dec 22 00:51:42 brooklyn-bridge /kernel: wi0: 802.11 address: 00:04:e2:57:80:f6
Dec 22 00:51:42 brooklyn-bridge /kernel: wi0: using RF:PRISM2 MAC:HFA3841 CARD:HWB3163 rev.A
Dec 22 00:51:42 brooklyn-bridge /kernel: wi0: Intersil Firmware: Primary 0.03.00, Station 0.08.03

Here is the configuration of the wireless card:

wi0: flags=8847<UP,BROADCAST,DEBUG,RUNNING,SIMPLEX,MULTICAST> mtu 1500
	inet6 fe80::204:e2ff:fe57:80f6%wi0 prefixlen 64 scopeid 0x2 
	inet 10.0.0.1 netmask 0xffffff00 broadcast 10.0.0.255
	ether 00:04:e2:57:80:f6
	media: IEEE 802.11 Wireless Ethernet autoselect <hostap> (DS/2Mbps <hostap>)
	status: associated
	ssid john_f_kennedy_international 1:john_f_kennedy_international
	stationname "FreeBSD AP"
	channel 7 authmode OPEN powersavemode OFF powersavesleep 100
	wepmode OFF weptxkey 1

Here is the client associated:

1 station:
00:30:65:07:fa:34  asid=0530, flags=3<ASSOC,AUTH>, caps=1<ESS>, rates=f<1M,2M,5.5M,11M>

Am I doing anything obviously wrong?

Thanks,
Johannes




To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message