panic: contigmalloc1 with 5.0

Karo Salminen <[email protected]>(by way of Karo Salminen <[email protected]>)
Newsgroups gmane.os.freebsd.devel.mobile
Message-ID <[email protected]>
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Greets,

FreeBSD 5.0-RELEASE GENERIC kernel gives me the following panic just after it
finds agp device:
panic: contigmalloc1: size must not be 0

Disabling ACPI from device.hints didn't help, so it's not ACPI issue.
I'm using Acer Travelmate 212TX.

Whole dmesg:

- - --BEGIN--
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.0-RELEASE #0: Mon Jan 20 02:15:35 EET 2003
    [email protected]:/usr/obj/annex/src/sys/GENERIC
Preloaded elf kernel "/boot//kernel/kernel" at 0xc0671000.
Preloaded elf module "/boot//kernel/acpi.ko" at 0xc06710ac.
Timecounter "i8254"  frequency 1193182 Hz
Timecounter "TSC"  frequency 797052687 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (797.05-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x68a  Stepping = 10

Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,P
A T,PSE36,MMX,FXSR,SSE>
real memory  = 259981312 (247 MB)
avail memory = 245624832 (234 MB)
Initializing GEOMetry subsystem
Pentium Pro MTRR support enabled
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <Acer   FALCON2M> on motherboard
    ACPI-0625: *** Info: GPE Block0 defined as GPE0 to GPE63
Using $PIR table, 5 entries at 0xc00fb9d0
acpi0: power button is handled as a fixed feature programming model.
Timecounter "ACPI-fast"  frequency 3579545 Hz
acpi_timer0: <32-bit timer at 3.579545MHz> port 0xf108-0xf10b on acpi0
acpi_cpu0: <CPU> on acpi0
acpi_tz0: <thermal zone> on acpi0
acpi_button0: <Sleep Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
agp0: <Ali Generic host to PCI bridge> mem 0xe0000000-0xe3ffffff at device
 0.0 on pci0
panic: contigmalloc1: size must not be 0
- - --END--

And below is the dmesg of working 4.7-STABLE:

- - --BEGIN--
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 4.7-STABLE #0: Wed Dec  4 16:31:50 EET 2002
    [email protected]:/usr/obj/annex/src/sys/GENERIC
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (797.05-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x68a  Stepping = 10

Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,P
A T,PSE36,MMX,FXSR,SSE>
real memory  = 259981312 (253888K bytes)
avail memory = 247721984 (241916K bytes)
Preloaded elf kernel "/kernel.GENERIC" at 0xc051c000.
Pentium Pro MTRR support enabled
md0: Malloc disk
pcibios: No call entry point
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <AcerLabs M5247 PCI-PCI(AGP Supported) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <Trident model 8620 VGA-compatible display device> at 0.0 irq 11
pci0: <unknown card> (vendor=0x10b9, dev=0x5451) at 6.0 irq 10
isab0: <AcerLabs M1533 portable PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <AcerLabs Aladdin ATA66 controller> port 0x7050-0x705f irq 15 at
device 16.0 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
chip1: <AcerLabs M15x3 Power Management Unit> at device 17.0 on pci0
pcic0: <O2micro 6812/6872 PCI-Cardbus Bridge> irq 11 at device 19.0 on pci0
pcic0: PCI Memory allocated: 0x88000000
pcic0: Warning: O2micro OZ68xx chips may not work
pccard0: <PC Card 16-bit bus (classic)> on pcic0
ohci0: <AcerLabs M5237 (Aladdin-V) USB controller> mem 0x81c00000-0x81c00fff
irq
 11 at device 20.0 on pci0
usb0: OHCI version 1.0, legacy support
usb0: <AcerLabs M5237 (Aladdin-V) USB controller> on ohci0
usb0: USB revision 1.0
uhub0: AcerLabs OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
orm0: <Option ROM> at iomem 0xc0000-0xcbfff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model IntelliMouse, device ID 3
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/7 bytes threshold
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
pccard: card inserted, slot 0
pccard: card removed, slot 0
ad0: 9590MB <IBM-DJSA-210> [19485/16/63] at ata0-master UDMA66
acd0: CDROM <TOSHIBA CD-ROM XM-7002Bc> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s1a
pccard: card inserted, slot 0
ed1 at port 0x300-0x31f irq 11 slot 0 on pccard0
ed1: address 00:20:cb:82:09:32, type NE2000 (16 bit)
- - --END--
- -- 
Karo Salminen
GSM: +358 45 6728280
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (FreeBSD)

iD8DBQE+LAO/vt6lNXuj7xcRArUmAJ4qS2FD5L7jjmu7OFJYiJ/ONtwDSgCfSsEV
78cptRCPS87kY7nFyKs98sc=
=K3B6
-----END PGP SIGNATURE-----


To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.