Re: wi0: No Mem space on prism2.5?
"WLAN" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Hi, I've checked my BIOS settings and PnP OS support is indeed disabled. I've tried this card in a different PC and get the same error message. It appears the problem is that the Wireless Card uses a PCI memory space that FreeBSD can't access. Thanx for the reply & info. Regards Craig Andrew Y Ng writes: > have you turned of PnP OS support in your BIOS? I came across the same > problem on a desktop with a PCI Netgear card, and it went away after i > disabled PnP OS support in the BIOS settings. > > /ayn > > On 0, WLAN <[email protected]> wrote: >> Hi, >> >> I'm trying to get a Pheenet WL-200 Wireless card working on my FreeBSD >> 4.7-RELEASE. >> >> It's based on the Prism II Chipset and is supported under Linux which I >> presume should also work in FreeBSD >> >> I have re-compiled my kernel for wireless support (wi0) however I get the >> following during bootup: >> >> wi0: <PheeNet WL-002> port 0x9300-0x933f,0x9200-0x920f irq 10 at device 15.0 >> on PCI0 >> wi0: No Mem space on prism2.5? >> device_probe_and_attach: wi0 attach returned 6 >> >> I did a clean install of FreeBSD 5.0-RELEASE and I get the same error >> message during bootup. >> >> Any ideas? >> >> Thanx >> >> >> To Unsubscribe: send mail to [email protected] >> with "unsubscribe freebsd-mobile" in the body of the message > > -- > andrew y ng <[email protected]> http://andrewng.com > independent computer consultants http://aynassociates.com > To Unsubscribe: send mail to [email protected] with "unsubscribe freebsd-mobile" in the body of the message