What?! no wi0 after a boot in windows

Hi !
Something strange happend..
I dual boot this laptop, and for the first time in months i booted in 
win2k, and because i havnt set up ipsec in win2k, i told win2k that i 
would like to push out the Netgear MA401 wireless card. (poweroff or 
something), but i really didnt. Just got the card to stop blinking as in 
searching for signal.

But to my great horror I had no wi0 more after boot. Dmesg told me this:
cbb0: <RF5C475 PCI-CardBus Bridge> irq 10 at device 5.0 on pci1
start (88000000) < sc->membase (e3800000)
end (ffffffff) > sc->memlimit (e6ffffff)
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
cbb0: bad Vcc request. ctrl=0xffffff88, status=0xffffffff
cbb_power: CARD_VCC_0V and CARD_VPP_0V [44]

And thats why I suspect that win2k action i took as the sinner in this 
headache...?!
I have tried to boot in win2k again, and there the cardworks just fine?!
What to do?

kind regards
Søren Vrist


To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message