Re: USB problem on Asus notebook

Alessandro,

please look into PR 33004. You will find there a patch which will fix your
problem. Actually I am writing this from an ASUS L7300 with an Logitech 
USB mouse...

Regards
	-Thorsten

On Tue, Apr 16, 2002 at 07:29:49PM +0200, Alessandro de Manzano wrote:
> On Tue, Apr 16, 2002 at 07:21:09PM +0200, Alessandro de Manzano wrote:
> 
> Uops, sorry, I forgot to include the complete dmesg report, could be
> more useful... here it is:
> 
> (note the "pci_cfgintr" messages)
> 
> 
> Copyright (c) 1992-2002 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
> 	The Regents of the University of California. All rights reserved.
> FreeBSD 4.5-RELEASE-p2 #0: Thu Apr 11 22:16:28 CEST 2002
>     [email protected]:/usr/obj/usr/src/sys/ASUS
> Timecounter "i8254"  frequency 1193182 Hz
> CPU: Pentium III/Pentium III Xeon/Celeron (498.16-MHz 686-class CPU)
>   Origin = "GenuineIntel"  Id = 0x683  Stepping = 3
>   Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
> real memory  = 201261056 (196544K bytes)
> avail memory = 191844352 (187348K bytes)
> Preloaded elf kernel "kernel" at 0xc03cc000.
> Preloaded userconfig_script "/boot/kernel.conf" at 0xc03cc09c.
> VESA: v2.0, 4096k memory, flags:0x0, mode table:0xc00c8ca7 (c0008ca7)
> VESA: Silicon Motion SM710 VGA BIOS
> Pentium Pro MTRR support enabled
> md0: Malloc disk
> Using $PIR table, 7 entries at 0xc00fdf50
> apm0: <APM BIOS> on motherboard
> apm: found APM BIOS v1.2, connected at v1.2
> npx0: <math processor> on motherboard
> npx0: INT 16 interface
> pcib0: <Intel 82443MX host to PCI bridge> on motherboard
> pci0: <PCI bus> on pcib0
> pcm0: <Intel 443MX> port 0x1000-0x103f,0x1400-0x14ff irq 15 at device 0.1 on pci0
> pci0: <unknown card> (vendor=0x0000, dev=0x0000) at 0.2
> pci0: <VGA-compatible display device> at 2.0
> isab0: <Intel 82443MX PCI to ISA bridge> at device 7.0 on pci0
> isa0: <ISA bus> on isab0
> atapci0: <Intel PIIX4 ATA33 controller> port 0x1800-0x180f at device 7.1 on pci0
> ata0: at 0x1f0 irq 14 on atapci0
> uhci0: <Intel 82443MX USB controller> port 0x1c00-0x1c1f at device 7.2 on pci0
> pci_cfgintr_linked: linked (63) to hard-routed irq 11
> pci_cfgintr: 0:7 INTD routed to irq 11
> usb0: <Intel 82443MX USB controller> on uhci0
> usb0: USB revision 1.0
> uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
> uhub0: 2 ports with 2 removable, self powered
> uhub0: device problem, disabling port 1
> chip1: <Intel 82443MX Power management controller> port 0x2180-0x218f at device 7.3 on pci0
> pci0: <unknown card> (vendor=0x134d, dev=0x7890) at 9.0 irq 10
> pci_cfgintr_linked: linked (60) to hard-routed irq 11
> pci_cfgintr: 0:10 INTA routed to irq 11
> pcic0: <Ricoh RL5C476 PCI-CardBus Bridge> irq 11 at device 10.0 on pci0
> pcic0: PCI Memory allocated: 0x44000000
> pccard0: <PC Card bus (classic)> on pcic0
> pci_cfgintr_search: linked (62) to configured irq 11 at 0:10:0
> pci_cfgintr: 0:10 INTB routed to irq 11
> pcic1: <Ricoh RL5C476 PCI-CardBus Bridge> irq 11 at device 10.1 on pci0
> pcic1: PCI Memory allocated: 0x44001000
> pccard1: <PC Card bus (classic)> on pcic1
> orm0: <Option ROM> at iomem 0xc0000-0xcbfff on isa0
> fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
> fdc0: FIFO enabled, 8 bytes threshold
> fd0: <1440-KB 3.5" drive> on fdc0 drive 0
> atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
> atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
> kbd0 at atkbd0
> psm0: <PS/2 Mouse> irq 12 on atkbdc0
> psm0: model GlidePoint, device ID 0
> vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
> sc0: <System console> at flags 0x100 on isa0
> sc0: VGA <16 virtual consoles, flags=0x300>
> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
> sio0: type 16550A
> sio1 at port 0x2f8-0x2ff irq 3 on isa0
> sio1: type 16550A
> ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
> ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
> lpt0: <Printer> on ppbus0
> lpt0: Interrupt-driven port
> ppi0: <Parallel I/O> on ppbus0
> DUMMYNET initialized (011031)
> BRIDGE 011031, have 3 interfaces
> IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to accept, logging limited to 100 packets/entry by default
> IP Filter: v3.4.20 initialized.  Default = pass all, Logging = enabled
> ata0-master: DMA limited to UDMA33, non-ATA66 compliant cable
> ad0: 5729MB <IBM-DARA-206000> [12416/15/63] at ata0-master UDMA33
> acd0: CDROM <CD-224E> at ata0-slave using PIO4
> Mounting root from ufs:/dev/ad0s1a
> pccard: card inserted, slot 1
> ed1 at port 0x300-0x31f irq 11 flags 0x80000 slot 1 on pccard1
> BRIDGE 011031, have 4 interfaces
> -- index 4  type 6 phy 0 addrl 6 addr 00.e0.98.39.07.df
> ed1: address 00:e0:98:39:07:df, type Linksys (16 bit) 
> ukphy0: <Generic IEEE 802.3u media interface> on miibus0
> ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
> 
> 
> To Unsubscribe: send mail to [email protected]
> with "unsubscribe freebsd-mobile" in the body of the message
> 

-- 
Mit freundlichen Gruessen / Best regards

Thorsten Greiner

-----------------------------------------------------------------
[email protected]                  ConSol* Software GmbH
Phone +49 2102/994-421                     Consulting & Solutions
Fax   +49 2102/994-411                          Berliner Str. 101
http://www.consol.de                             D-40880 Ratingen

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message