Bluetooth on FreeBSD

Hello,

I'm quite new to FreeBSD and I'm trying to install the Bluetooth
protocol stack developed by Maksim Yevmenkin. I'm not sure what it's
called, other than ngbt-fbsd?

I've been following the instructions from Pav's BSD corner at
http://www.oook.cz/bsd/bluetooth.html.

After building the modules, editing the /boot/loader.conf file and
reboot the system, I plug in the USB Bluetooth device, the system
detects a USB device being plugged in.

However, I do not get the following expected output on the console:
ubt0: vendor 0x0a12 product 0x0001, rev 1.10/5.25, addr 2
ubt0: Interface 0 endpoints: interrupt=0x81, bulk-in=0x82, bulk-out=0x2
ubt0: Interface 1 (alt.config 5) endpoints: isoc-in=0x83, isoc-out=0x3;
      wMaxPacketSize=49; nframes=6, buffer size=294

This output may be redirected to a syslog file. What is the name and
location of the log file?

I've successfully setup a Bluetooth PAN on Linux Debian systems where I
had to mount a USB bus at /proc/bus/usb. Is this also necessary on
FreeBSD? 

I am using FreeBSD 5.0-RELEASE with an USB Ericsson Bluetooth training
kit.

Input on this matter would be greatly appreciated. Thanks in advance.

Indika

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"