APM problems under FreeBSD 5.1-RELEASE on IBM Thinkpad A30p
"Jesse D. Guardiani" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Organization | WingNET Internet Services |
| Message-ID | <[email protected]> |
Howdy list, I'm again trying to get some form of power management operational under FreeBSD. (If I can't, I'm not going back to Linux. I'll just deal with it! But it would certainly be nice....) I have APM compiled into my kernel. I do this at the boot prompt: unset hint.apm.0.disabled set hint.acpi.0.disabled=1 And apm is detected fine at boot. When I run 'apm' as root, it says apm is disabled. So I run 'apm -e enable'. Then I run 'apm' as root again, and it says apm management is enabled. So, I do 'apm -z', and my system suspends properly. BUT, when I bring it out of suspend: The screen comes back on-line properly. Firewire reinits properly. A few more messages go by... But then it says something like 'initializing ATA devices', and I get a terrible un-ending beep from the speakers. There's no getting around it. I never get my prompt back and I have to power down the machine. This is all from a text console. No X. Any ideas anyone? -- Jesse Guardiani, Systems Administrator WingNET Internet Services, P.O. Box 2605 // Cleveland, TN 37320-2605 423-559-LINK (v) 423-559-5145 (f) http://www.wingnet.net _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"