5.1R questions O2Micro, ACPI
Markus D. <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Hi, yesterday I installed 5.1R on my laptop (dual-booting with 4.8R) and was happy that it worked without any big problems. But as I'm new to -current I have a few questions: 1. APM is deprecated and ACPI seems to work. As far a I read, acpiconf is used to make the machine sleep. How can I determine the current power mode and battery state? apm still gives information about that, but is that correct? When booting, there are "system power profiles" set. How can I set this? When pushing the "sleep" button on my box, I get the error ' acpi0: AcpiGetSleepTypeData failed - AE_NOT_FOUND ' Can anybody tell me what this means and what I can do? 2. Then there is the neverending O2Micro story. I'm using 5.1R GENERIC. Here is the part from dmesg: cbb0: <O2Micro OZ6812/6872 PCI-CardBus Bridge> mem 0x88000000-0x88000fff irq 11 at device 3.0 on pci0 cardbus0: <CardBus bus> on cbb0 pccard0: <16-bit PCCard bus> on cbb0 2a) Do I still need to run pccardd under 5.1? And what function does pccard.conf have? 2b) If I insert a card, simply _nothing_ happens. I had a similar behaviour with 4.8 when I had no free irq in pccard.conf. Thank you for your help... Markus D. _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"