Re: cardbus network problem with -current

On Wed, Jul 02, 2003 at 18:53:40 -0600, M. Warner Losh wrote:
> In message: <[email protected]>
>             "Kenneth D. Merry" <[email protected]> writes:
> : On Wed, Jul 02, 2003 at 16:15:06 -0600, M. Warner Losh wrote:
> : > In message: <[email protected]>
> : >             "Kenneth D. Merry" <[email protected]> writes:
> : > : On Wed, Jul 02, 2003 at 01:48:21 -0600, M. Warner Losh wrote:
> : > : > Does this also happen if you boot off the battery?  When booting off
> : > : > the battery, your CPU is running slower (if the 8500 is like my 8000),
> : > : > and maybe this is a timing problem.
> : > : 
> : > : The same thing happens when I boot off the battery.
> : > 
> : > I suppose the same thing happens if you boot w/o the card in the
> : > socket, and do one of the following:
> : > 
> : > 1) insert the card after the machine is on, but before the kernel is
> : >    loaded.
> : 
> : Yep, fails the same way.
> : 
> : > 2) after cbb has probed, but before we get to the point of mounting
> : >    root.
> : 
> : Fails the same way.
> : 
> : > 3) Some point after init starts.
> : 
> : It fails the same way.  I have to pop it out and re-insert it.
> 
> So even if you wait until the machine is completely up, you have to
> insert it twice before it will work?

Yes.

> : > And does it happen when you reboot the machine with the card in place?
> : > Eg, is this a cold boot only problem, warm boot problem, or both?
> : 
> : It doesn't matter whether it's a cold or a warm boot, or whether the card
> : was functional or not on the last boot, every time I reboot it doesn't work.
> : 
> : Once I re-insert it, it works fine.
> 
> OK.  That's good to know.  Sounds like a "first time always fails"
> problem...

Yeah.

> Oh, one last thing.  Could you try the following experiment.  Don't
> build cardbus into your kernel.  Omit cbb, cardbus and pccard.  Make
> sure you install the modules, however.  Also, set the loader for
> automatic module loading for these three modules.  Then you can do:
> 
> 	1) insert card
> 	2) boot
> 	3) reinsert card

Probed both times.

> 	4) kldunload cbb		(or cardbus in second experiment)
> 	5) kldload cbb			    ditto

Card probed here when I unloaded and reloaded cbb, but did not probe here
when I unloaded and reloaded cardbus.

> 	6) reinsert card

Card probed here both times.

> If it is a 'the bios puts the hardware in a funny state' problem, then
> the card should attach at #5 instead of #6.  I think this is a pci
> cardbus bridge driver problem of some sort and this would help me sort
> it out.  I know it is a little bit of a pain, but it may suggest a
> patch..

It attached at #5 when I loaded the cbb module, but not the cardbus module.

Ken
-- 
Kenneth Merry
[email protected]
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"