More Broadcom BCM5705 updates
[email protected] (Bill Paul)
| Newsgroups | gmane.os.freebsd.current,gmane.os.freebsd.devel.net,gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
I have merged in some additional updates provided by Paul Saab:
- Support the BCM5782 chip (5705 workalike, new PCI ID)
- Increase firmware handshake timeout
- Always check for GMII PHYs at PHY address 1 (required for
some chips, doesn't hurt on the others)
- Add ASIC rev numbers for 5705_A1, 5705_A2 and 5705_A3
There may be some additional performance tweaks needed, but this should
get the device attached and working. As before, download the new code
from:
http://www.freebsd.org/~wpaul/Broadcom/5705
- Copy if_bge.c and if_bgereg.h to /sys/dev/bge
- Copy miidevs and brgphy.c to /sys/dev/mii
- Rebuild your kernel and/or if_bge.ko and miibus.ko modules
-Bill
--
=============================================================================
-Bill Paul (510) 749-2329 | Senior Engineer, Master of Unix-Fu
[email protected] | Wind River Systems
=============================================================================
"If stupidity were a handicap, you'd have the best parking spot."
=============================================================================
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "[email protected]"