Re: dmesg showing wrong frequency (IBM T30)
"Kevin Oberman" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <20030718174840.5FFEE5D07__17301.012381404$1058550504@ptavv.es.net> |
> Date: Fri, 18 Jul 2003 19:24:20 +0200 > From: Tobias Roth <[email protected]> > Sender: [email protected] > > On Fri, Jul 18, 2003 at 06:22:27PM +0200, Poul-Henning Kamp wrote: > > What's "wrong" here is that the BIOS/ACPI firmware in your laptop > > runs your CPU at a reduced rate in order to make the battery last > > longer. > > it should NOT do this. I set the bios to disable speedstep and to > 'max performance' while on AC. also, i run apm and not acpi. > > > It can also be that the case that the "cooling solution" (ie: fans, > > fins etc) does not work well enough and the ACPI code has slowed > > down the CPU in order to not melt anything [*]. > > that was also one of my suspicions. the fan is brand new, ibm replaced > it after i sent the unit in because of heat problems. > > could it be that the design of this laptop is bad, when it comes to > heat conduction? > > shouldn't i get the full 1.8GHz when running on AC, and be able to > do a buildworld without any sig11 on a hot summer day (~28 deg c room > temp). those sig11 are just another thing that may be connected to my > low cpu freq... I have not had any issue running a buildworld on my T30 on a hot day. (It hit 105 at my house yesterday and 103 at Lawrence Livermore about 3 miles away.) It runs at 1.8 GHz and takes under an hour to build CURRENT, about 35% longer than it took with STABLE. No 11s sighted. It does get HOT..too hot to really be a laptop unless you have well insulated pants, but within spec for temperature. (At least with ACPI running so that I can monitor the temperature.) The exhaust vent is blowing a strong stream of very warm air. I do see messages that the system is switching between performance and economy mode when I switch from AC to battery, but the CPU pays no attention and the speed stays unchanged under both APM and ACPI. :-( It sounds like something is very wrong with your T30. -- R. Kevin Oberman, Network Engineer Energy Sciences Network (ESnet) Ernest O. Lawrence Berkeley National Laboratory (Berkeley Lab) E-mail: [email protected] Phone: +1 510 486-8634 _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"