Toshiba Laptop Page Fault in pccard_scan_cis

Raymond Jimenez <[email protected]>
Newsgroups gmane.os.freebsd.devel.mobile
Message-ID <[email protected]>
	I have an old Toshiba laptop (225 CDS) that's been working fine with 
PCMCIA cards until I upgraded to -CURRENT. In 4.8-RELEASE, FreeBSD 
recognized the slots fine, and detected the cards as well. However, in 
-CURRENT, it doesn't detect the cards or the slots. In 4.8, the cards 
were in the mode "PCIC-Compatible" in the BIOS. This mode didn't work 
with -CURRENT, and so I turned it to "CardBus/16-Bit". -CURRENT 
recognizes the slots, but whenever a card is present on bootup or when 
one is inserted (after loading the modules) I get the following page fault:

shirayuki# kldload cardbus
shirayuki# kldload pccard
shirayuki# kldload cbb
cbb0: <ToPIC95B PCI-CardBus Bridge> irq 11 at device 2.0 on pci0
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
cbb1: <ToPIC95B PCI-CardBus Bridge> irq 11 at device 2.1 on pci0
cardbus1: <CardBus bus> on cbb1
pccard1: <16-bit PCCard bus> on cbb1


Fatal trap 12: page fault while in kernel mode
fault virtual address   = 0xc64cb000
fault code              = supervisor read, page not present
instruction pointer     = 0x8:0xc15f36b5
stack pointer           = 0x10:0xc61d694c
frame pointer           = 0x10:0xc61d6b64
code segment            = base 0x0, limit 0xfffff, type 0x1b
                         = DPL 0, pres 1, def32 1, gran 1
processor eflags        = interrupt enabled, resume, IOPL = 0
current process         = 502 (cbb0)
kernel: type 12 trap, code=0
Stopped at      pccard_scan_cis+0x175:  movzbl  0(%eax,%edx,1),%eax
db>


output of dmesg:

Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
         The Regents of the University of California. All rights reserved.
FreeBSD 5.1-CURRENT #0: Sun Jul 20 20:45:11 PDT 2003
     [email protected]:/usr/obj/usr/src/sys/SHIRAYUKI
Preloaded elf kernel "/boot/kernel/kernel" at 0xc05c2000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc05c21cc.
Timecounter "i8254"  frequency 1193182 Hz
Timecounter "TSC"  frequency 132632637 Hz
CPU: Pentium/P54C (132.63-MHz 586-class CPU)
   Origin = "GenuineIntel"  Id = 0x52c  Stepping = 12
   Features=0x1bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8>
real memory  = 67239936 (64 MB)
avail memory = 59207680 (56 MB)
Intel Pentium detected, installing workaround for F00F bug
VESA: v2.0, 2048k memory, flags:0x0, mode table:0xc051d660 (1000040)
VESA: CHIPS 6x554 Super VGA
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcibios: BIOS version 2.10
Using $PIR table, 3 entries at 0xc00f97e0
pcib0: <Host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
pci_cfgintr: 0:2 INTA BIOS irq 11
pci_cfgintr: 0:2 INTB BIOS irq 11
pci_cfgintr: 0:11 INTA BIOS irq 11
pci0: <bridge, PCI-CardBus> at device 2.0 (no driver attached)
pci0: <bridge, PCI-CardBus> at device 2.1 (no driver attached)
pci0: <display, VGA> at device 4.0 (no driver attached)
ohci0: <NEC uPD 9210 USB controller> mem 0xfdfff000-0xfdffffff irq 11 at 
device 11.0 on pci0
usb0: OHCI version 1.0
usb0: <NEC uPD 9210 USB controller> on ohci0
usb0: USB revision 1.0
uhub0: NEC OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
isa0: <ISA bus> on motherboard
pmtimer0 on isa0
ata0 at port 0x3f6,0x1f0-0x1f7 irq 14 on isa0
ata1 at port 0x376,0x170-0x177 irq 15 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model GlidePoint, device ID 0
fdc0: <NEC 765 or clone> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/16 bytes threshold
ppbus0: <Parallel port bus> on ppc0
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x100>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A, console
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
pca0: <AT-style speaker sound> at port 0x61 on isa0
unknown: <PNP0303> can't assign resources (port)
unknown: <TOS7400> can't assign resources (irq)
unknown: <PNP0700> can't assign resources (port)
unknown: <PNP0600> can't assign resources (port)
unknown: <PNP0600> can't assign resources (port)
unknown: <PNP0501> can't assign resources (port)
unknown: <PNP0401> can't assign resources (port)
pcm0: <Yamaha OPL-SAx> at port 
0x370-0x371,0x330-0x331,0x388-0x38b,0x530-0x537,0x220-0x22f irq 5 drq 
0,1 on isa0
Timecounters tick every 10.000 msec
IPsec: Initialized Security Association Processing.
IP Filter: v3.4.31 initialized.  Default = block all, Logging = enabled
ad0: 7815MB <IBM-DYLA-28100> [15880/16/63] at ata0-master PIO4
acd0: CDROM <TOSHIBA CD-ROM XM-1602B> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s1a

output of uname -a:
FreeBSD shirayuki.wsyntax.com 5.1-CURRENT FreeBSD 5.1-CURRENT #0: Sun 
Jul 20 20:45:11 PDT 2003 
[email protected]:/usr/obj/usr/src/sys/SHIRAYUKI  i386

I've looked on Google and found a few threads detailing this discussion, 
but the thread ended with "Oh, with some card/bridge combinations, we 
don't map the CIS address space correctly." The man pages don't say 
anything about this.

Any help would be greatly appreciated.
-Raymond

-- 
Raymond Jimenez ("Cyanoacry") <[email protected]>
http://chikage.wsyntax.com <> [email protected]

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.