RE: ACPI and INT-Routing
John Baldwin <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On 30-Jul-2003 Markus D. wrote: >> >> > I have seen in DMESG output from people posting to this list entries >> > like 'slot 31 INTD is routed to irq 3'. Is it an error not to have such >> > lines on booting with acpi? >> >> It is not an error, per se. It may mean that your BIOS doesn't >> support interrupt routing, but I doubt that. >> >> > Instead the irq's are displayed along with the driver lines on booting. >> >> Can you provide an example of this? >> > It look's like this (with OLDCARD) > > pcic0: <O2micro 6812/6872 PCI-Cardbus Bridge> irq 11 at device 3.0 on pci0 > pcic0: PCI Memory allocated: 0x88000000 > pcic0: Polling mode > pcic0: Warning: O2micro OZ68xx chips may not work > pccard0: <PC Card 16-bit bus (classic)> on pcic0 Can you provide your full dmesg? -- John Baldwin <[email protected]> <>< http://www.FreeBSD.org/~jhb/ "Power Users Use the Power to Serve!" - http://www.FreeBSD.org/ _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"