Thinkpad 600x and Netgear FA411 PCMCIA card

I have a Thinkpad 600x (TI-1450 CardBus Controller) and a Netgear FA411
PCMCIA NIC I'm trying to get working with FreeBSD.  This card works fine
when I boot into WinXP, but not when using FBSD.  Any ideas what I should do
to get the two talking under FreeBSD?

uname -a:
FreeBSD bart.greyhound.dyndns.org 5.1-RELEASE FreeBSD 5.1-RELEASE #2: Tue
Jul 29 22:47:54 EDT 2003	root@:/usr/src/sys/i386/compile/BART	i386

and from dmesg:
found->	vendor=0x104c, dev=0xac1b, revid=0x03
		bus=0, slot=2, func=0
		class=06-07-00, hdrtype=0x02, mfdev=1
		cmdreg=0x0007, statreg=0x0210, cachelnsz=8 (dwords)
		lattimer=0xa8 (5040 ns), mingnt=0xc0 (48000 ns), maxlat=0x03 (750 ns)
		intpin=a, irq=11
		powerspec 1 supports D0 D1 D2 D3 current D0
		map[10]: type 1, range 32, base 50102000, size 12, enabled
found->	vendor=0x104c, dev=0xac1b, revid=0x03
		bus=0, slot=2, func=1
		class=06-07-00, hdrtype=0x02, mfdev=1
		cmdreg=0x0007, statreg=0x0210, cachelnsz=8 (dwords)
		lattimer=0xa8 (5040 ns), mingnt=0xc0 (48000 ns), maxlat=0x03 (750 ns)
		intpin=b, irq=11
		powerspec 1 supports D0 D1 D2 D3 current D0
		map[10]: type 1, range 32, base 50101000, size 8, enabled
		map[14]: type 4, range 32, base 00004500, size 3, enabled
		map[18]: type 4, range 32, base 00004400, size 8, enabled

cbb0: <TI1450 PCI-CardBus Bridge> mem 0x50103000-0x50103fff irq 11 at device
2.0 on pci0
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
cbb0: cbb_power: CARD_VCC_0V and CARD_VPP_0V [44]
cbb1: <TI1450 PCI-CardBus Bridge> mem 0x5010200-0x50102fff irq 11 at devive
2.1 on pci0
cardbus1: <CardBus bus) on cbb1
pccard1: <16-bit PCCard bus> on cbb1
cbb1: cbb_power: CARD_VCC_0V and CARD_VPP_OV [44]

cbb1: card inserted: event=0x00000000, state=30000510
pccard1: chip_socket_enable
cbb_pcic_socket_enable:
cbb1: cbb_power: CARD_VCC_0V and CARD_VPP_0V [44]
cbb1: cbb_power: CARD_VCC_5V and CARD_VPP_VCC [15]
pccard1: read_cis
cis mem map cf633000
pccard1: CIS tuple chain:
CISTPL_END
 ff
cis mem map cf633000
CISTPL_LINKTARGET expected, code ff observed
pccard1: check_cis_quirks
pccard1: Card has no functions!
cbb1: PC Card card activation failed


Any ideas on this?

-nc

--
Nathan Clark


_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"