Re: Problems with XFree 4.3/FreeBSD and a Inspiron 5100.
Peter Losher <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Fri, 1 Aug 2003, Greg Lehey wrote: > > Thanks for the pointer, because of the flaky support for Cardbus in > > 5.1, I am still using 4.8-STABLE. > > CardBus is much better under 5.1 than 4.8. There are problems with > the Inspiron 5100, but that's not general. Tell me about it :( I will likley try 5.1R again with the loader.conf changes Joe Clarke suggested earlier. > > (Cardbus just locks up the system during boot) > > This must depend on the card. I haven't had that kind of problem. > What's the card? When does it hang? Netgear WG511 D-Link DWL-650+ And a Netgear MA401RA PC Card did the same thing. Let's see what happens with at least the 16-bit PC Card after the loader.conf changes. Best Wishes - Peter -- [ http://www.plosh.net/ ] - "Earth Halted : Please Reboot" _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"