Re: Vaio 505GL PC-CARD (pccardd) problmes

Hello

hw.pci.allow_unsupported_io_range=1  did the trick...thanks for your help..

My linksys  WPC11 card works now... However the WPC54G does not... I get the 
following error message when I put teh 54G in.. Do you have anymore ticks up 
your sleve that might help me out... :) I might be wrong but I don't think 
there is any support yet for the Linksys 54G card.

Aug  4 21:25:37 vaio kernel: start (88000000) < sc->membase (e0200000) 
Aug  4 21:25:37 vaio kernel: end (ffffffff) > sc->memlimit (e02fffff) 
Aug  4 21:25:37 vaio kernel: start (88000000) < sc->membase (e0200000) 
Aug  4 21:25:37 vaio kernel: end (ffffffff) > sc->memlimit (e02fffff) 
Aug  4 21:25:37 vaio kernel: cardbus0: <network> at device 0.0 (no driver 
attached)

Aug  4 21:25:37 vaio kernel: cbb0: CardBus card activation failed 
Aug  4 21:25:37 vaio dhclient: DHCPREQUEST on fxp0 to 192.168.0.1 port 67 
Aug  4 21:25:37 vaio dhclient: DHCPACK from 192.168.0.1 
Aug  4 21:25:37 vaio dhclient: New Network Number: 192.168.0.0 
Aug  4 21:25:37 vaio dhclient: New Broadcast Address: 192.168.0.255 
Aug  4 21:25:37 vaio dhclient: bound to 192.168.0.153 -- renewal in 282 
seconds.
 


On Mon, 4 Aug 2003 18:12:45 -0700, Marcel Moolenaar wrote
> On Mon, Aug 04, 2003 at 07:16:47PM -0500, Chris Collins wrote:
> > I am running 5.1-current and I think that i read somwhere NEWCARD is 
default. 
> > I am not sure how else to tell or show to switch. 
> > 
> > I have two a linksys WPC11 Wireless Card & and Linksys WPC54G card that I 
am 
> > trying to get working. 
> > 
> > Below is my pccard.conf and dmesg.boot
> 
> Do you have the following in /boot/loader.conf?
> 	hw.pci.allow_unsupported_io_range=1
> 
> You should get something like:
> 
> 	:
> FreeBSD 5.1-CURRENT #0: Fri Aug  1 22:29:03 PDT 2003
>     [email protected]:/usr/obj/usr/src/sys/VAIO
> 	:
> CPU: Mobile Intel(R) Pentium(R) III CPU - M  1200MHz (1193.11-MHz 
> 686-class CPU) 	: acpi0: <SONY   C1      > on motherboard 	: 
cbb0: 
> <RF5C475 PCI-CardBus Bridge> irq 9 at device 5.0 on pci2 start 
> (88000000) < sc->membase (e0200000) end (ffffffff) > sc->memlimit 
> (e02fffff) cardbus0: <CardBus bus> on cbb0 pccard0: <16-bit PCCard 
> bus> on cbb0 	: start (88000000) < sc->membase (e0200000) end 
> (ffffffff) > sc->memlimit (e02fffff) start (88000000) < sc->membase 
> (e0200000) end (ffffffff) > sc->memlimit (e02fffff) wi0: <Lucent 
> Technologies WaveLAN/IEEE> at port 0x100-0x13f irq 9 function 0 
> config 1 on pccard0 	: wi0: bad alloc 2ba != ff, cur 0 nxt 0 	:
> 
> PS: Don't send pccard.conf. We all have it ourselves. Just send us
> the additions, removals or modifications only.
> 
> -- 
>  Marcel Moolenaar	  USPA: A-39004		 [email protected]


_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"