Re: wi0_cmd: busy bit won't clear
Daniel Eischen <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Sun, 10 Aug 2003, M. Warner Losh wrote: > In message: <[email protected]> > Daniel Eischen <[email protected]> writes: > : > Finally I got a stack backtrace "lock order reversal". Uhh, it > : > seems a mess. > > Can you post it (again?)? > > : > And even if I get it working by manually configuring the card, > : > what is the problem, who is gonna fix it and when? > : > : Warner (imp@) is the PCCard guy :-) > > I'm coming in on the middle of this converstation. Manually > configuring the card? I'm not sure what you mean by this. Sometimes, and it's not often or repeatable, when the system boots with the card inserted, I get that error (wi0_cmd: busy...) and it hangs for a bit. I'm using /etc/start_if.wi0 to set the ssid and have DHCP enabled on it. I get a few of those messages, and then it (or DHCP) gives up and the system continues booting as normal. After the system is up, the card is not associated but it does have the ssid set. Running ifconfig at this point also hangs for a bit and I get the error message again. If I remove the card and reinsert it, I can manually configure it and it works. Removing the card while booting also works. -- Dan Eischen _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"