Re: Compaq Evo N410c sound?

On Fri, Aug 22, 2003 at 10:30:15PM +0200, Robert Blacqui?re wrote:
> Did you do also a MAKEDEV snd in /dev ?
> 
> Robert
> 
> On Fri, Aug 22, 2003 at 03:50:02PM -0400, stan wrote:
> > On Sun, Jul 27, 2003 at 07:02:41PM +0200, Robert Blacqui?re wrote:
> > > As i know there is a maestro3 chipset used. 
> > > 
> > > using 
> > > 
> > > kldload snd_maestro3.ko 
> > > 
> > > should work and adding 
> > > 
> > > load_snd_maestro3=yes to /boot/loader.conf 
> > > 
> > > should enable sound during boot
> > > 
> > > 
> > > 
> > > On Sun, Jul 27, 2003 at 12:20:59PM -0400, stan wrote:
> > > > What do I need to do to make sound work on my Compaq Evo N410C under
> > > > STABLE?
> > > > 
> > 
> > I just got back to this, and I was able to load this module, which also
> > apparently loaded the snd_pcm module as a dependency.
> > 
> > That's the good news, the bad news is that sound still does not work. Gnome
> > says it can't find the sound device. mp3baster agrees, that it can't open
> > the sound device, and penguin-command is a bit more specific, saying that
> > /dev/dsp is not configured. I've checked and the device file is made for
> > this.
> > 
> > What else might I be missing?
> > 
> > 
> > BTW, I tried all of these as root to remove permissions issues from the
> > picture (I hope).
> > 

./MAKEDEV sndo with the cwd == /dev, right?

Just did that, still no sound :-(

-- 
"They that would give up essential liberty for temporary safety deserve
neither liberty nor safety."
						-- Benjamin Franklin
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"