No mouse on Dell Inspirion 1100?

I just configured a Dell Inspirion 1100 laptop for a friend ... and
this laptop has a built in touch pad ... much like my dell.  It's
running -CURRENT cvsup'd as of Monday.  When it probes the mouse (full
-v boot below), it get's this error (boot -v'd)

pci0: <simple comms> at device 31.6 (no driver attached)
unknown: not probed (disabled)
psmcpnp0 irq 12 on acpi0
atkbdc0: <Keyboard controller (i8042)> port 0x66,0x62,0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
atkbd: the current kbd controller command byte 0065
atkbd: keyboard ID 0x41ab (2)
kbd0 at atkbd0
kbd0: atkbd0, AT 101/102 (2), config:0x1, flags:0x3d0000
psm0: current command byte:0065
psm0: the aux port is not functioning (-1).
unknown: not probed (disabled)

I'm somewhat at a loss ... as I really don't know how to proceed.
Help?

full boot -v follows:

Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD 5.1-CURRENT #0: Tue Aug 26 18:37:07 EDT 2003
    root@lute:/usr/obj/usr/src/sys/LUTE
Preloaded elf kernel "/boot/kernel/kernel" at 0xc0616000.
Preloaded elf module "/boot/kernel/snd_ich.ko" at 0xc06161f4.
Preloaded elf module "/boot/kernel/snd_pcm.ko" at 0xc06162a0.
Preloaded acpi_dsdt "/boot/Dell.aml" at 0xc061634c.
Preloaded elf module "/boot/kernel/if_bcm.ko" at 0xc0616390.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc061643c.
Calibrating clock(s) ... i8254 clock: 1193205 Hz
CLK_USE_I8254_CALIBRATION not specified - using default frequency
Timecounter "i8254" frequency 1193182 Hz quality 0
Calibrating TSC clock ... TSC clock: 2192893472 Hz
CPU: Intel(R) Celeron(R) CPU 2.20GHz (2192.89-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0xf29  Stepping = 9
  Features=0xbfebf9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM,PBE>
real memory  = 535597056 (510 MB)
Physical memory chunk(s):
0x0000000000001000 - 0x000000000009efff, 647168 bytes (158 pages)
0x000000000063d000 - 0x000000001f5a7fff, 519483392 bytes (126827 pages)
avail memory = 513597440 (489 MB)
bios32: Found BIOS32 Service Directory header at 0xc00ffe80
bios32: Entry = 0xffe90 (c00ffe90)  Rev = 0  Len = 1
pcibios: PCI BIOS entry at 0xf0000+0xcfae
pnpbios: Found PnP BIOS data at 0xc00fe2d0
pnpbios: Entry = f0000:e2f4  Rev = 1.0
pnpbios: Event flag at 4b4
Other BIOS signatures found:
wlan: <802.11 Link Layer>
null: <null device, zero device>
random: <entropy source>
mem: <memory & I/O>
Pentium Pro MTRR support enabled
ACPI: DSDT was overridden.
    ACPI-0375: *** Info: Table [DSDT] replaced by host OS
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <DELL   CPi R  > on motherboard
pci_open(1):	mode 1 addr port (0x0cf8) is 0x80000050
pci_open(1a):	mode1res=0x80000000 (0x80000000)
pci_cfgcheck:	device 0 [class=060000] [hdr=00] is there (id=25608086)
pcibios: BIOS version 2.10
Using $PIR table, 10 entries at 0xc00fcbb0
PCI-Only Interrupts: none
Location  Bus Device Pin  Link  IRQs
embedded    0   29    A   0x60  3 4 5 6 7 9 10 11 12 14 15
embedded    0   29    B   0x63  3 4 5 6 7 9 10 11 12 14 15
embedded    0   29    C   0x62  3 4 5 6 7 9 10 11 12 14 15
embedded    0   29    D   0x6b  3 4 5 6 7 9 10 11 12 14 15
embedded    0   30    A   0x60  3 4 5 6 7 9 10 11 12 14 15
embedded    0   30    B   0x61  3 4 5 6 7 9 10 11 12 14 15
embedded    0   30    C   0x62  3 4 5 6 7 9 10 11 12 14 15
embedded    0   30    D   0x63  3 4 5 6 7 9 10 11 12 14 15
embedded    0   31    A   0x62  3 4 5 6 7 9 10 11 12 14 15
embedded    0   31    B   0x61  3 4 5 6 7 9 10 11 12 14 15
embedded    0    2    A   0x60  3 4 5 6 7 9 10 11 12 14 15
embedded    1    0    A   0x65  3 4 5 6 7 9 10 11 12 14 15
embedded    2    1    A   0x61  3 4 5 6 7 9 10 11 12 14 15
embedded    2    4    A   0x60  3 4 5 6 7 9 10 11 12 14 15
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"