Re: pc-card ethernet problems since upgrade from 4.2

Kal Torak <[email protected]>
Newsgroups gmane.os.freebsd.devel.mobile
Organization Quake Networking
Message-ID <[email protected]> 
Ian Dowse wrote:
> 
>>ed1: address 00:50:ba:74:11:49, type Linksys (16 bit) 
>>ukphy0: <Generic IEEE 802.3u media interface> on miibus0
>>ukphy0: OUI 0x0010dd, model 0x0001, rev. 2
>>ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
>>ed1: device timeout
>>ed1: device timeout
> 
> 
> The ed driver currently doesn't do auto-negotiation correctly for
> these cards, but if you are connected to a 100Mbits switch, the
> card usually starts working after a few `device timeout' messages.

Well it is connected to a 100mbit switch.. But never starts working
properly..

When trying to ping anything it says:

sendto: host is down


To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.