Xircom Credit Card Ethernet CEM56-100 : xe

Hi everybody,

I installed FreeBSD 5.1 from CD on my IBM Thinkpad T22 which works really
good. I need to use a Xircom Credit Card Ethernet CEM56-100 with it,
mostly because I specially checked with the hardware support list before I
actually buy the card. Now I have a problem with it. I searched the whole
archive of the freebsd-xircom mailing list and tried to read comments on
this device. But the "ifconfig"  still doesn't recognize the XE0 as an
ethernet interface.

The command "pccardc dumpcis" answers with: "0 slots found" The pccard
daemon "pccardd" does not run at startup and when I start it manually it
says:"pccardd[773]: fatal error: no PC-CARD slots"

Surprisingly, each time, I insert the card into the running system I get
the following message:

xe0: <Xircom CreditCard Ethernet 10/100 + Modem 56> at port 0x2
e8-0x2ef irq 11 function 0 config 39 on pccard0
device_probe_and_attach: xe0 attach returned 19

The modem doesn't work either, eventhough I tried to uncomment the entry
in the pccard.conf.

Following is my dmesg. Since it might have been unpleasent to look at a
long system message, I tried to delete many lines which (I thought) are
not related to the topic. The XE is at the end.

I would appreciate any comments on this.

Bests,
Shahab.

********** My DMESG ******************************

pcibios: BIOS version 2.10
Using $PIR table, 11 entries at 0xc00fdee0
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> at pcibus 0 on
motherboard
pci0: <PCI bus> on pcib0
pcib1: <PCIBIOS PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <display, VGA> at device 0.0 (no driver attached)
cbb0: <TI1450 PCI-CardBus Bridge> mem 0x50000000-0x50000fff irq 11 at
device 2.0 on pci0
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
cbb1: <TI1450 PCI-CardBus Bridge> mem 0x50100000-0x50100fff irq 11 at
device 2.1 on pci0
cardbus1: <CardBus bus> on cbb1
pccard1: <16-bit PCCard bus> on cbb1
csa0: <CS4280/CS4614/CS4622/CS4624/CS4630> mem
0xe8000000-0xe80fffff,0xe8100000-0xe8100fff irq 11 at device 5.0 on pci0
csa: card is Thinkpad 600X/A20/T20
isab0: <PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 UDMA33 controller> port 0x1800-0x180f at device 7.1
on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0x1820-0x183f irq 11
at device 7.2 on pci0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
pci0: <bridge, PCI-unknown> at device 7.3 (no driver attached)
orm0: <Option ROMs> at iomem
0xe0000-0xeffff,0xdc000-0xdffff,0xc0000-0xcbfff on isa0
pmtimer0 on isa0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: 16550A
unknown: <PNP0303> can't assign resources (port)
unknown: <PNP0c02> can't assign resources (port)
unknown: <IBM3780> can't assign resources (irq)
unknown: <PNP0700> can't assign resources (port)
unknown: <PNP0680> can't assign resources (port)
unknown: <PNP0680> can't assign resources (port)
unknown: <PNP0400> can't assign resources (port)
xe0: <Xircom CreditCard Ethernet 10/100 + Modem 56> at port 0x2e8-0x2ef
irq 11 function 0 config 39 on pccard0
device_probe_and_attach: xe0 attach returned 19



_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"