Re: PCCARD on Toshiba Satellite 5100 (5105)

On Tue, Oct 07, 2003 at 07:23:54PM -0600, M. Warner Losh wrote:
> In message: <[email protected]>
>             Gabriele Cecchetti <[email protected]> writes:
> : I've istalled 5.1-RELEASE on Toshiba Satellite 5100-503 (the European 
> : model of Satellite 5105...)
> : When I boot I get the following messages:
> : 
> : ...
> : cbb0: <TI1410 PCI-CardBus Bridge> at device 10.0 on pci2
> : cbb1: <ToPIC100 PCI-CardBus Bridge> at device 11.0 on pci2
> : cbb1: bad Vcc request. ctrl=0xffffff88, status=0xffffffff
> : cbb2: <ToPIC100 PCI-CardBus Bridge> at device 11.1 on pci2
> : cbb2: bad Vcc request. ctrl=0xffffff88, status=0xffffffff
> 
> Hmmm.  ToPIC bridge.  I don't have a lot of experience with these
> bridges with newbus (I don't have any topic laptops!).

My 3 year old ToPIC100 using Toshiba Satellite 2805 worked just fine
with 5.x from 5.0-RELEASE onward.  My primary network connection was
an 802.11b card.  The laptop is currently dead due to the solder joint
holding the power jack to the MoBo breaking.  (My soldering skills
suck in confined spaces.  My irons are probably all too large for this
project too.)
 
> : So the cardbus did not get inizialized well and I cannot see
> : my wireless card and my CF card.
> 
> Is your wireless card built into the unit (likely connected to the ti
> chip), or some kind of 16-bit PC Card or a CardBus card?
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"