Re: Infrared support

Benjamin Close <[email protected]>
Newsgroups gmane.os.freebsd.devel.mobile
Message-ID <[email protected]>
Not knowing the specs of your built in port you might be right.
However, I use it with the build in irda port of my Dell Inspiron 8000 
Laptop.
Although FreeBSD recognises that port as a serial port:

sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A

sio is the irda port of my laptop.

Cheers,
    Benjamin

Vince Hoffman wrote:

>Thanks for the advice, unfortunately this just confirms my ignorance about
>irda under freebsd ;)
>
>If I correctly understand my (second and closer) reading of the pkg-desc,
>birda only works on serial port dongles ?
>"A set of utilities to communicate with IrDA devices over an IrDA port
>on a serial line."
>
>So my built in infrared port wont work. (toshiba type-0.) Is this correct ?
>(guess i buy a dongle if so.)
>
>Thanks
>Vince
>
>
>----- Original Message -----
>From: "Benjamin Close" <[email protected]>
>To: "Vince Hoffman" <[email protected]>
>Cc: <[email protected]>
>Sent: Monday, October 27, 2003 1:36 AM
>Subject: Re: Infrared support
>
>
>  
>
>>Hi Vince,
>>    I use irda support quite frequently. Here's a section from my ppp.conf
>>should help you out a fair bit.
>>
>>ppp.conf
>># create a connection: ircomm -d /dev/cuaa1 -v 2 -y /dev/ptypv
>>TelstraMobileInternet:
>> set phone +61418707638
>> set device /dev/ttypv
>> set authname xxx
>> set authkey xxx
>> set dial "ABORT BUSY ABORT NO\\sCARRIER TIMEOUT 5 \"\" AT \
>>           OK-AT-OK ATE1Q0 OK \\dATDT\\T TIMEOUT 40 CONNECT"
>>
>>
>>Vince Hoffman wrote:
>>
>>    
>>
>>>Hi all,
>>>
>>>       I actualy asked on freebsd-questions previously but got no
>>>      
>>>
>answers so i though i'd try here.
>  
>
>>>I Have a Toshiba Tecra happily running 4.8-RELEASE, (cant get 5.x running
>>>      
>>>
>but thats another issue) and i would like to use my mobile phone (nokia
>7110) as a modem, i can do this happily on win2k (i dual boot,) but would
>like to get it going for FreeBSD also.
>  
>
>>>   By googling around a bit i gather i needed to install birda, which i
>>>      
>>>
>did, but i'm now stuck as it seems rather short on documentation.
>  
>
>>>Can anyone point me in the right direction to get my laptop and phone
>>>      
>>>
>working ?
>  
>
>>>Thanks
>>>Vince
>>>_______________________________________________
>>>[email protected] mailing list
>>>http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
>>>To unsubscribe, send any mail to "[email protected]"
>>>
>>>
>>>      
>>>
>>--
>>3D Research Associate / System Administrator     +61 8 8302 3669
>>School of Computer and Information Science       Room D1-07, ML Campus
>>University of South Australia                    Mawson Lakes Blvd.
>>[email protected]                   South Australia, 5095
>>F00D C83D 5F7E 5561 DF91  B74D E602 CAA3 4842 B5B4
>>
>>
>>_______________________________________________
>>[email protected] mailing list
>>http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
>>To unsubscribe, send any mail to "[email protected]"
>>
>>    
>>


-- 
3D Research Associate / System Administrator     +61 8 8302 3669
School of Computer and Information Science       Room D1-07, ML Campus
University of South Australia                    Mawson Lakes Blvd.
[email protected]                   South Australia, 5095
F00D C83D 5F7E 5561 DF91  B74D E602 CAA3 4842 B5B4


_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.