Help getting Compaq Wireless LAN card working
stan <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
I am trying to get my Compaq wireless LAN card for my N410C working.
I've looked at:
http://www.samag.com/documents/s=7121/sam0205a/sam0205a.htm
Given that information, I've added the apropriate itmes to my kernle (It's
a device awi Prisim chipset, right?).
Now when I boot the machine I get the following in dmesg:
ugen0: Compaq Computers Compaq WLAN MultiPort W200, rev 1.10/0.00, addr 2
and if config looks like this:
fxp0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet 205.159.77.8 netmask 0xffffff00 broadcast 205.159.77.255
ether 00:d0:59:c6:41:bf media: Ethernet autoselect (10baseT/UTP)
status: active lp0: flags=8810<POINTOPOINT,SIMPLEX,MULTICAST>
mtu 1500
faith0: flags=8003<UP,BROADCAST,MULTICAST> mtu 1500
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
inet 127.0.0.1 netmask 0xff000000 ppp0: flags=8010<POINTOPOINT,MULTICAST>
mtu 1500
sl0: flags=c010<POINTOPOINT,LINK2,MULTICAST> mtu 552
So it's the faith0 device, right?
But when I run:
brown2# wicontrol -f 7
wicontrol: SIOCSWAVELAN: Device not configured
So, what steps have I left out? Or am I confused?
--
"They that would give up essential liberty for temporary safety deserve
neither liberty nor safety."
-- Benjamin Franklin
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"