Re: Netgear FA410TX

Hi Warren,

If you add "-z" to pccard_flags in rc.conf, pccardd will wait for any cards
to attach before running as a daemon.  Then the IP address can be assigned
automatically from the settings in rc.conf rather than being configured
manually.

Scott.



----- Original Message -----
From: "Warren Block" <[email protected]>
To: <[email protected]>
Sent: Sunday, March 24, 2002 4:03 AM
Subject: Re: Netgear FA410TX


> On Sat, 23 Mar 2002, Warren Block wrote:
>
> > Frustratingly, I had this card working for a few moments, managed to
> > ping out and ran lynx to go to the FreeBSD web site.
>
> Discovered, just now, is that if I set PCIC in the Tecra BIOS, let it
> boot and wait up to a minute or so, then assign an IP address to the
> 410TX, it pops up and works.  All three lights on the dongle are on,
> indicating 100BaseTX, full duplex, and a link.
>
> Could this be an autonegotiation problem?
>
> -Warren Block * Rapid City, South Dakota USA
>
>
> To Unsubscribe: send mail to [email protected]
> with "unsubscribe freebsd-mobile" in the body of the message
>
>



To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message