NEWCARD CardBus Problems

Hey!
I was trying to get my NetGear FA511 CardBus working, and it wasn't
recognized on loading. Anyone have any hints on what I should do to
troubleshoot this? Should I try something else in NEWCARD.hints?
Any leads are welcome!

dmesg below...

Thanks,

Mike Stoppelman

Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD 5.0-DP1 #6: Sun May  5 23:51:28 AST 2002
    root@:/usr/obj/usr/src/sys/NEWCARD
Preloaded elf kernel "/boot/kernel/kernel" at 0xc047a000.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc047a0a8.
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (744.47-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x683  Stepping = 3

Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory  = 134152192 (131008K bytes)
avail memory = 125812736 (122864K bytes)
Pentium Pro MTRR support enabled
Using $PIR table, 8 entries at 0xc00fdf40
apm0: <APM BIOS> on motherboard
apm0: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: Other PM system enabled.
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> at pcibus 0 on
motherboard
pci0: <PCI bus> on pcib0
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <display, VGA> at device 0.0 (no driver attached)
isab0: <PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xfc90-0xfc9f at device 7.1
on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0: <serial bus, USB> at device 7.2 (no driver attached)
pci0: <bridge, PCI-unknown> at device 7.3 (no driver attached)
pci0: <serial bus, FireWire> at device 8.0 (no driver attached)
pci0: <multimedia, audio> at device 9.0 (no driver attached)
pci0: <simple comms> at device 10.0 (no driver attached)
pccbb0: <RF5C478 PCI-CardBus Bridge> at device 12.0 on pci0
cardbus0: <CardBus bus> on pccbb0
pccard0: <16-bit PCCard bus> on pccbb0
pci_cfgintr_linked: linked (60) to hard-routed irq 9
pci_cfgintr: 0:12 INTA routed to irq 9
pccbb1: <RF5C478 PCI-CardBus Bridge> at device 12.1 on pci0
cardbus1: <CardBus bus> on pccbb1
pccard1: <16-bit PCCard bus> on pccbb1
pci_cfgintr_linked: linked (61) to hard-routed irq 9
pci_cfgintr: 0:12 INTB routed to irq 9
orm0: <Option ROM> at iomem 0xc0000-0xcbfff on isa0
fdc0: <enhanced floppy controller (i82077, NE72065 or clone)> at port
0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model GlidePoint, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
pmtimer0 on isa0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
cardbus0: Expecting link target, got 0x59
cardbus0: Resource not specified in CIS: id=10, size=100
cardbus0: Resource not specified in CIS: id=14, size=400
cardbus0: <unknown card> (vendor=0x1317, dev=0x1985) at 0.0 irq 9
pccbb0: CardBus card activation failed
ata1-slave: ATAPI identify retries exceeded
ad0: 17301MB <FUJITSU MHJ2181AT> [35152/16/63] at ata0-master UDMA33
acd0: DVD-ROM <TOSHIBA DVD-ROM SD-C2402> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s2a
fd0: autoselected 1440 KB medium



To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message