Re: pcm ain't working - running 5.1 on Thinkpad 600
Davis Doherty <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Thu, 4 Dec 2003, Kevin Oberman wrote: [SNIP] > >First, your pcm.0.flags probably should be 0x10. You probably also will >need hint.pcm.o.port="0x52c". > >Finally, if this is a 600E you need to edit >/sys/conf/files. delete/comment out "dev/sound/pci/csa.c optional pcm >pci" (be careful that you get the right one!) and edit the line after >next to read "dev/sound/pci/csapcm.c optional csa pcm pci". I'm not >confident that this is needed on a 600, though. > >FWIW, by probe line for the sound reads: >pcm0: <CS423x-PCI> at port 0x220-0x233,0x388-0x38b,0x530-0x537 irq 5 drq >0,1 on isa0 > >It is a rather out-of-date system as it takes forever to build world and >it's only a test system. It was built back in June, but I doubt that any >of this has changed. Also, my 600E did not gat along with ACPI at all >well and I use APM on it. >-- >R. Kevin Oberman, Network Engineer >Energy Sciences Network (ESnet) >Ernest O. Lawrence Berkeley National Laboratory (Berkeley Lab) >E-mail: [email protected] Phone: +1 510 486-8634 > I tried both changes, to no avail (my system is a plain old 600 btw, no letters following). Regardless of my settings, the appropriate device nodes in /dev are not being created (and thus nothing sound-related works). Is there any way I can force creation of the device nodes, or will they just not be created until I find the correct settings? -Davis Doherty _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"