Re: ACPI/PCI-bus issue with compaq evo n160
Wilko Bulte <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Wed, Dec 17, 2003 at 01:40:03PM -0500, John Baldwin wrote: > > On 17-Dec-2003 Fredrik Lindberg wrote: > > The solution suggested by Mauritz worked, the ACPI stuff works now. > > This is what I have in my loader.conf > > > > debug.acpi.disable="lid pci_link" > > hw.pci.allow_unsupported_io_range="1" > > hw.cbb.start_memory="536870912" > > What if you remove the debug.acpi.disable line? The system hangs during boot just after printing "Mounting root <foo>" > >> Also for I have > >> hw.cbb.start_memory="0xd0208000" > >> since pci/pcib allocates the memory assigned to fxp0 by BIOS to pccard otherwise. > > This sounds like the root problem of the interrupt storm. Not likely, as I have not redefined it on my N160. I had to set the unsupported I/O range thingy but that is all. > >> Now I always use acpiconf -s S4 to suspend and save to disk instead of turning the power off, > >> wonderful. > > Wish S4 worked on my laptops. :-P I probably need a suspend partition, so mine does not do S4 ;) Laptops... <blurk> W/ -- | / o / /_ _ |/|/ / / /( (_) Bulte [email protected] _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"