EZ Connect SMC 802.11B Card?
"Ryan Dewalt" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Running 5.2-RC, on a Dell Inspiron 5000, I've got a 3Com Cardbus 10/100 that works just fine, however, when I try my EZ Connect SMC Networks card, I get: cardbus0: Expecting link target, got 0x0 cardbus0: Resource not specified in CIS: id=10, size=100 cardbus0: Resource not specified in CIS: id=14, size=400 cardbus0: <network> at device 0.0 (no driver attached) cbb0: CardBus card activation failed I have wlan,an,awi,wi,wl (basically all of the Wireless NIC cards section from GENERIC) compiled in. Any suggestions? Some Googling seems to show that the card might -not- be supported yet, it seems to be based on the ADM8211 chipset, and further googling shows that ADMtek does provide both a Linux driver, and source code. (http://www.admtek.com.tw/download/ADM8211.htm) Has anyone ported this to FreeBSD? I would give it a try, however I will admit that porting this is far above my skill level. Suggestions? Thanks in advance, -Ryan Dewalt _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"