RE: Problem with Intel 2011b

I haven't tried the NEWCARD stuff (it panics my hp 510 - 16bit bridge chips)
so I can't comment on that.  

Did you try booting with the card installed?  If you boot verbose
(boot -v) should see it dump the pci id contents.  Also check
if /etc/defaults/pccard.conf contains an entry for the card.  The
version of -current I have (maybe a few days old) has no entry
explicitly for a 2011B.  It might use the same entry as a 2011,
but might have a different id string.  I've exceeded my knowledge
at this point, so I'll stop speculating.  

Over to you, Warner :-)

-----Original Message-----
From: John Angelmo [mailto:[email protected]]
Sent: 13 May 2002 16:15
To: [email protected]
Cc: [email protected]; [email protected]
Subject: Re: Problem with Intel 2011b


[email protected] wrote:
> I have used the non-B version with -current and an IBM thinkpad.
> 
> What kind of laptop?  dmesg output would be nice.
> Do any other cards work?
> 
> Alan Edmonds
> 
> -----Original Message-----
> From: John Angelmo [mailto:[email protected]]
> Sent: 13 May 2002 15:02
> To: current
> Cc: freebsd-mobile
> Subject: Problem with Intel 2011b
> 
> 
> Hello
> 
> I just got my hands on a Intel 2011b Wireless card, I'm running FreeBSD 
> current (dated just before gcc 3.1).
> Now my problem is that I insert the card and well nothing happens, the 
> system gets locked, when I remove the card I everything starts working 
> once again, and it says it can't manage card ("null"), ("null")
> 
> Any one got any idea?
> 
> mvh /John
> 
> 
> To Unsubscribe: send mail to [email protected]
> with "unsubscribe freebsd-current" in the body of the message
> 
> To Unsubscribe: send mail to [email protected]
> with "unsubscribe freebsd-current" in the body of the message

Well 2011b is a 32bit card (if I'm not mistaking) the 2011 card is the 
same as the symbol card but the 2011b card uses 3.3v instead of 5v

So perhaps I need to use:
device          pccbb                   # cardbus (yenta) bridge
device          pccard
device          cardbus

instead of:
device          card            # pccard bus
device          pcic            # PCMCIA bridge

What else can I do?

I use a C Series Lifebook from Fujitsu Siemens

/John

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message