Re: cbb: can't map IRQ...

On Thursday 11 March 2004 01:18 pm, José Nicolás Castellano wrote:
> Sorry, i haven't disket or cdrom, the only way to install is by another
> notebook and moving harddisk.
>
> ACPI is not activated as a module and as a kernel, and the dmesg output is
> exactly the same as before and adding $PIR:ROUTE_INTERRUPT failed to every
> pci device.
>
> If you think i can type something to extract more verbose tell me please

Well, if you do a 'boot -v' from the boot prompt (or choose the verbose item 
from the menu) you will get a lot more messages.  Of specific interest will 
be things like the $PIR table that gets dumped, the list of $PIR links that 
gets dumped 3 or 4 times, and any other message with 'PIR' in them.

> Thank you
>
> ----- Original Message -----
> Subject: Re: cbb: can't map IRQ...
>
> > On Thursday 11 March 2004 11:41 am, José Nicolás Castellano wrote:
> > > Sorry, now with CURRENT kernel, I can get in every device the next
>
> message
>
> > > in dmesg:
> > >
> > > pci0:<bridge,pci-unknown) at device 1.3(no driver attached)
> > > $PIR:ROUTE_INTERRUPT failed
> > >
> > > What is happening?
> >
> > Can you get a verbose dmesg with ACPI disabled?  I need some more info to
>
> try
>
> > and figure this out.

-- 
John Baldwin <[email protected]>  <><  http://www.FreeBSD.org/~jhb/
"Power Users Use the Power to Serve"  =  http://www.FreeBSD.org
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"