More TrueMobile 1300

I have a TrueMobile 1300 PCMCIA card.  I have compiled and successfully loaded 
the NDIS drivers (5-Current as of 8pm last night).  The card is detected on 
insert.  Despite all this, all I can seem to do with it is turn the power led 
on and off (ifconfig up/down).  The wicontrol -l command lists the AP in my 
network.  If I configure the interface with the SSID and keys it will never 
associate.  I know a few people have said they have it working, so I am 
wondering what I am doing wrong.  Can anyone make sense of the mess below?

Is it normal for the PCMCIA card to show "Mini-PCI" on insert.  Is this 
because the drivers are the same for both cards?
dmesg:
ndis0: <Dell TrueMobile 1300 WLAN Mini-PCI Card> mem 0x88002000-0x88003fff irq 
10 at device 0.0 on cardbus1
ndis0: NDIS API version: 5.0
ndis0: 802.11 address: 00:10:c6:30:ed:98
ndis0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
ndis0: 11g rates: 6Mbps 9Mbps 12Mbps 18Mbps 36Mbps 48Mbps 54Mbps

ifconfig:
ndis0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        inet6 fe80::210:c6ff:fe30:ed98%ndis0 prefixlen 64 scopeid 0x4
        ether 00:10:c6:30:ed:98
        media: IEEE 802.11 Wireless Ethernet autoselect
        status: no carrier
        ssid ""
        channel 11 authmode OPEN powersavemode OFF powersavesleep 100
        wepmode MIXED weptxkey 1
        wepkey 1:40-bit

wicontrol:
IC serial number:                      [  ]
Station name:                           [ xxx.amduat.net ]
SSID for IBSS creation:                 [ xxx ]
Current netname (SSID):                 [  ]
Desired netname (SSID):                 [ xxx ]
Current BSSID:                          [ 00:00:00:00:00:00 ]
Channel list:                           [ ffff ffff ffff ffff ffff ffff ffff 
ffff ffff ffff ffff ffff ffff ffff ffff 3fff ]
IBSS channel:                           [ 11 ]
Current channel:                        [ 11 ]
Comms quality/signal/noise:             [ 0 0 0 ]
Promiscuous mode:                       [ Off ]
Intersil-Prism2 based card:             [ 1 ]
Port type (1=BSS, 3=ad-hoc):            [ 1 ]
MAC address:                            [ xx:xx:xx:xx:xx:xx ]
TX rate (selection):                    [ 0 ]
TX rate (actual speed):                 [ 0 ]
RTS/CTS handshake threshold:            [ 2312 ]
Create IBSS:                            [ Off ]
Access point density:                   [ 1 ]
Power Mgmt (1=on, 0=off):               [ 0 ]
Max sleep time:                         [ 100 ]
WEP encryption:                         [ On ]
TX encryption key:                      [ 1 ]
Encryption keys:                        [ xxxxx ][  ][  ][  ]

wicontrol -l:
1 station:
ap[0]:
        netname (SSID):                 [ xxx ]
        BSSID:                          [ xx:xx:xx:xx:xx:xx ]
        Channel:                        [ 1 ]
        Quality/Signal/Noise [signal]:  [ 104 / 104 / 0 ]
                                [dBm]:  [ 104 / -45 / -149 ]
        BSS Beacon Interval [msec]:     [ 0 ]
        Capinfo:                        [ WEP ]
        DataRate [Mbps]:                [ 11 ]

-- 
Jacob S. Barrett
[email protected]
www.amduat.net

"I don't suffer from insanity, I enjoy every minute of it."
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"