Re: Flash Reader/Writer
Greg Troxel <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Basically these readers are usually to be umass, which look like a
umass, then a scsibus and then a scsi disk. I have a SanDisk SDDR-91
which works fine on NetBSD, and I think worked on FreeBSD earlier.
It seems that the sandisk imagemate products conform to the standards,
so they are a good bet.
The following is from sticking a 256MB CF into a sandisk reader (on
netbsd-current, but the usb code is very similar).
umass0 at uhub0 port 1 configuration 1 interface 0
umass0: SanDisk ImageMate CF, rev 2.00/1.19, addr 2
umass0: using SCSI over Bulk-Only
scsibus1 at umass0: 2 targets, 1 lun per target
sd0 at scsibus1 target 0 lun 0: <Generic, STORAGE DEVICE, 0119> disk removable
sd0: fabricating a geometry
sd0: 245 MB, 245 cyl, 64 head, 32 sec, 512 bytes/sect x 501760 sectors
sd0: fabricating a geometry
--
Greg Troxel <[email protected]>
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"