Re: X configuration for laptop

On 19 May 2004 at 19:05, Shaun T. Erickson wrote:

> I am trying to install FreeBSD 5.2.1 on a laptop, for the first time.
> The OS install went fine. But I don't know what to do to configure X.
> 
> It's an almost 4 year old "Dell Lattitude CPx J750GT". The video
> controller is an "ATI M1", with 8 MB of memory. Looking up my spcific
> system on the Dell support site, it's display is described as an
> "Liquid Crystal Display, TFT, 14.1, CRNA, Samsung", Dell part# 4564E.

You can get more information aobut your display via "pciconf -lv" 
(well, that's how I found out I have a Savage video controller).  
Look for "display" or "VGA".

> 
> I skipped X configuration, during the install. As root, I ran "XFree86
> -configure" to generate a config file, and tested it with "XFree86
> -xf86config XF86Config.new", which worked just as the handbook said it
> should. I do not know what values to use to set the HorizSync,
> VertRefresh, Depth or Modes.
> 
> I did try running "/stand/sysinstall" and going to the X setup
> section. Trying the graphical setup causes the system to lock up. I
> have previously run Red Hat 9 on this system and X worked ok on it,
> right up until I erased it yesterday, so I believe there are no
> hardware issues. I suppose I should have looked at it's X settings,
> but I neglected to do so before blowing it away ...
> 
>  -ste
> _______________________________________________
> [email protected] mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
> To unsubscribe, send any mail to
> "[email protected]"
> 


-- 
Dan Langille : http://www.langille.org/
BSDCan - http://www.bsdcan.org/

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"