/kernel: pcic0: Card type none (can't happen) is unsupported

Hi,

The last month I get the following message once every second:

/kernel: pcic0: Card type none (can't happen) is unsupported

What could be the problem? Everything is working fine though.

Some system information:

# pccardc dumpcis
Configuration data for card in slot 1
Tuple #1, code = 0x1 (Common memory descriptor), length = 2
    000:  00 ff
        Common memory device information:
                Device number 1, type No device, WPS = OFF
                Speed = No speed, Memory block size = reserved, 32 units
Tuple #2, code = 0x17 (Attribute memory descriptor), length = 3
    000:  43 02 ff
        Attribute memory device information:
                Device number 1, type EEPROM, WPS = OFF
                Speed = 150nS, Memory block size = 8Kb, 1 units
Tuple #3, code = 0x20 (Manufacturer ID), length = 4
    000:  01 01 74 05
        PCMCIA ID = 0x101, OEM ID = 0x574
Tuple #4, code = 0x21 (Functional ID), length = 2
    000:  06 00
        Network/LAN adapter
Tuple #5, code = 0x15 (Version 1 info), length = 29
    000:  04 01 33 43 6f 6d 00 4d 65 67 61 68 65 72 74 7a
    010:  20 35 37 34 42 00 42 00 30 30 31 00 ff
        Version = 4.1, Manuf = [3Com], card vers = [Megahertz 574B]
        Addit. info = [B],[001]
Tuple #6, code = 0x1a (Configuration map), length = 6
    000:  02 03 00 00 01 03
        Reg len = 3, config register addr = 0x10000, last config = 0x3
        Registers: XX------ 
Tuple #7, code = 0x1b (Configuration entry), length = 15
    000:  c1 01 1d 71 55 35 55 54 e0 72 5d 65 30 ff ff
        Config index = 0x1(default)
        Interface byte = 0x1 (I/O)
        Vcc pwr:
                Nominal operating supply voltage: 5 x 1V
                Max current average over 1 second: 3 x 10mA
                Max current average over 10 ms: 5 x 10mA
                Power down supply current: 5 x 1mA
        Wait scale Speed = 7.0 x 100 ns
        RDY/BSY scale Speed = 5.0 x 100 us
        Card decodes 5 address lines, full 8/16 Bit I/O
                IRQ modes: Level
                IRQs:  0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Tuple #8, code = 0x19 (JEDEC descr for attribute memory), length = 3
    000:  00 00 ff
Tuple #9, code = 0x14 (No link), length = 0
Tuple #10, code = 0x10 (Checksum), length = 5
    000:  ae ff 5b 00 00
        Checksum from offset 65454, length 91, value is 0x0
Tuple #11, code = 0xff (Terminator), length = 0
2 slots found

Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights
reserved.
FreeBSD 4.6-RC #0: Mon May 20 13:06:35 CEST 2002
    [email protected]:/usr/obj/usr/src/sys/TP
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (647.76-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x681  Stepping = 1
 
Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory  = 201129984 (196416K bytes)
avail memory = 192454656 (187944K bytes)
Preloaded elf kernel "kernel" at 0xc0317000.
netsmb_dev: loaded
Pentium Pro MTRR support enabled
md0: Malloc disk
pcibios: No call entry point
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on
pci0
pci1: <PCI bus> on pcib1
pci1: <NeoMagic MagicMedia 256ZX SVGA controller> at 0.0 irq 11
pcic0: <TI PCI-1450 PCI-CardBus Bridge> mem 0x3000-0x3fff irq 11 at
device 2.0 on pci0
pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr
save][FUNC pci int + CSC serial isa irq]
pccard0: <PC Card bus (classic)> on pcic0
pcic1: <TI PCI-1450 PCI-CardBus Bridge> mem 0x50102000-0x50102fff irq 11
at device 2.1 on pci0
pcic1: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr
save][FUNC pci int + CSC serial isa irq]
pccard1: <PC Card bus (classic)> on pcic1
pci0: <unknown card> (vendor=0x11c1, dev=0x0449) at 3.0 irq 11
pci0: <unknown card> (vendor=0x1013, dev=0x6003) at 6.0 irq 11
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xfcf0-0xfcff at device 7.1
on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0x4000-0x401f irq
11 at device 7.2 on pci0
usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
chip1: <Intel 82371AB Power management controller> port 0xefa0-0xefaf at
device 7.3 on pci0
orm0: <Option ROM> at iomem 0xc0000-0xcbfff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on
isa0
fdc0: FIFO enabled, 8 bytes threshold
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on
isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: cannot reserve I/O port range
pccard: card inserted, slot 1
ad0: 28615MB <FUJITSU MHN2300AT> [58140/16/63] at ata0-master UDMA33
acd0: DVD-ROM <TOSHIBA DVD-ROM SD-C2302> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s2a

regards,
	jonas

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message